Lantronix EDS32PR EDS - User Guide - Page 115
Protocol Stack Settings, TCP Settings
View all Lantronix EDS32PR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
14: Maintenance and Diagnostics Settings Protocol Stack Settings In the Protocol Stack web page, you can configure TCP, IP, ICMP, SMTP and ARP. TCP Settings To configure the TCP network protocol: 1. Select Protocol Stack on the menu bar. 2. Select TCP. Figure 14-4 TCP Protocol 3. Modify the following settings: Protocol Stack TCP Settings Send RSTs Ack Limit Send Data Table 14-5 TCP Protocol Settings Description Click Enabled to send RSTs or Disabled to stop sending RSTs. TCP contains six control bits, with one or more defined in each packet. RST is one of the control bits. The RST bit is responsible for telling the receiving TCP stack to end a connection immediately. Note: Setting the RSTs may pose a security risk. Enter a number to limit how many packets get received before an ACK gets forced. If there is a large amount of data to acknowledge, an ACK gets forced. If the sender TCP implementation waits for an ACK before sending more data even though the window is open, setting the Ack Limit to 1 packet improves performance by forcing immediate acknowledgements. The Send Data selection governs when data may be sent into the network. The Standard implementation waits for an ACK before sending a packet less than the maximum length. Select Expedited to send data whenever the window allows it. EDS User Guide 115