Lantronix PremierWave 2050 User Guide - Page 24
: Network Settings, Access Point, To Con Access Point Settings, Using Web Manager
View all Lantronix PremierWave 2050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
5: Network Settings Network settings for the PremierWave 2050 module can be viewed and modified under the Network tab in the Web Manager user interface. This chapter describes the following network settings: Access Point Bridge Wired (eth0) Network Wireless (wlan0) Network Protocol Stack Wi-Fi Protected Setup WLAN Scan/QuickConnect WLAN Profiles Configuring WLAN Profile Settings Access Point Configure software-enabled access point interface on this page. Access point status information displays at the top of the page. Access Point Field State IP Address Network Name (SSID) Security Suite Passphrase Show Password (check box) Table 5-1 Access Point Settings Description Select to enable or disable the access point. If enabled, the DHCP server will assign IP addresses to the access point clients. Enter the IP address of the SoftAP interface. Specify the network name/SSID of the access point. The SSID update will take effect after the device is rebooted. Select a security suite to be used with the access point. Enter a passphrase if WPA or WPA2 security suite is selected above. Check to make the passphrase entered to the left visible. To Configure Access Point Settings Using Web Manager To configure access point settings, on the Networks page, click Access Point. Using the CLI To enter the command level: enable -> config -> access point Using XML Include in your file: PremierWave® 2050 Enterprise Wi-Fi® IoT Module User Guide 24