Lenovo H100 Lenovo 3000 H Series Hardware Replacement Guide V3.0 - Page 15

Replacing hardware

Page 15 highlights

Chapter Replacing hardware Attention Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com Note: Use only parts provided by Lenovo. Removing the computer cover Important Turn off the computer and wait 3 to 5 minutes to let the computer cool before removing the computer cover. To remove the computer cover: 1. Before removing any media (diskettes, CDs, or memory cards) from the drives, shut down your operating system, turn off all attached devices, and the computer. 2. Unplug all power cords from electrical outlets. 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O) cables, and any other cables that are connected to the computer. Refer to "Locating connectors on the rear of the computer". 4. Remove the two screws that secure the computer cover at the rear of the 12 Hardware Replacement Guide 31040542_3000 H_HRG_EN_V3.0.indd12 12 2009.9.7 2:41:33 PM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29

±²
Hardware Replacement Guide
Attention
Do not remove the computer cover or attempt any repair before reading the
“Important safety information” in the
Safety and Warranty Guide
that was
included with your computer or in the
Hardware Maintenance Manual
(HMM)
for the computer. To obtain copies of the
Safety and Warranty Guide
or
HMM
, go to the Support Web site at http://consumersupport.lenovo.com
Note:
Use only parts provided by Lenovo.
Removing the computer cover
Important
Turn off the computer and wait 3 to 5 minutes to let the computer cool
before removing the computer cover.
To remove the computer cover:
1.
Before removing any media (diskettes, CDs, or memory cards) from the drives,
shut down your operating system, turn off all attached devices, and the
computer.
2.
Unplug all power cords from electrical outlets.
3.
Disconnect all cables attached to the computer. This includes power cords,
input/output (I/O) cables, and any other cables that are connected to the
computer. Refer to “Locating connectors on the rear of the computer”.
4.
Remove the two screws that secure the computer cover at the rear of the
Replacing hardware
Chapter
31040542_3000 H_HRG_EN_V3.0.indd12
12
2009.9.7
2:41:33 PM