Lenovo H330 Lenovo H3 Series Hardware Maintenance Manual V2.0 - Page 37

To replace the optical drive

Get Lenovo H330 PDF manuals and user guides View all Lenovo H330 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 37 highlights

Chapter 8. Replacing hardware To replace the optical drive 1. Remove the computer cover. Refer to "Removing the computer cover". 2. Remove the front bezel. Refer to "Removing the front bezel". 3. Remove the 2 screws that secure the optical disk bay to the chassis. 4. Slide out then lift up the optical disk drive bay. 2 1 5. Disconnect the data and power cables from the rear of the optical drive. 6. Remove the 4 screws that secure the optical drive to the optical disk bay and push the optical drive straight out of the front of the disk bay. 3 2 1 7. Slide the new optical drive into the bay from the front, screw it back to the disk bay. 8. Connect the data and power cables to the drive. 9. Slide in then push the optical disk drive bay back in, and then screw it back to the chassis. 10. Install back the fromt bezel and computer cover. 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
Chapter 8. Replacing hardware
35
To replace the optical drive
1.
Remove the computer cover. Refer to “Removing the computer cover”.
2.
Remove the front bezel. Refer to “Removing the front bezel”.
3.
Remove the 2 screws that secure the optical disk bay to the chassis.
4.
Slide out then lift up the optical disk drive bay.
2
1
5.
Disconnect the data and power cables from the rear of the optical drive.
6.
Remove the 4 screws that secure the optical drive to the optical disk
bay and push the optical drive straight out of the front of the disk bay.
2
1
3
7.
Slide the new optical drive into the bay from the front, screw it back to
the disk bay.
8.
Connect the data and power cables to the drive.
9.
Slide in then push the optical disk drive bay back in, and then screw it
back to the chassis.
10. Install back the fromt bezel and computer cover.