Lenovo H330 Lenovo H3 Series Hardware Maintenance Manual V2.0 - Page 39

Replacing the hard disk drive

Page 39 highlights

Chapter 8. Replacing hardware 6. Position the new memory module over the memory connector. Make sure the notch on the memory aligns correctly with the connector key on the system board. Push the memory module straight down into the connector until the retaining clips close. 7. Install the optical disk drive bay. 8. Install back the fromt bezel and computer cover. Replacing the hard disk drive Attention Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com To replace the hard disk drive 1. Remove the computer cover. Refer to "Removing the computer cover". 2. Remove the front bezel. Refer to "Removing the front bezel". 3. Remove the optical disk bay. Refer to "Replacing the optical drive". 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56

Chapter 8. Replacing hardware
37
6.
Position the new memory module over the memory connector. Make
sure the notch
on the memory aligns correctly with the connector
key
on the system board. Push the memory module straight down
into the connector until the retaining clips close.
7.
Install the optical disk drive bay.
8.
Install back the fromt bezel and computer cover.
Replacing the hard disk drive
Attention
Do not remove the computer cover or attempt any repair before
reading the “Important safety information” in the
Safety and Warranty
Guide
that was included with your computer or in the
Hardware
Maintenance Manual
(HMM) for the computer. To obtain copies of the
Safety and Warranty Guide
or
HMM
, go to the Support Web site at
To replace the hard disk drive
1.
Remove the computer cover. Refer to “Removing the computer cover”.
2.
Remove the front bezel. Refer to “Removing the front bezel”.
3.
Remove the optical disk bay. Refer to “Replacing the optical drive”.