Lenovo IdeaCentre K230 IdeaCentre K220 Hardware Replacement Guide - Page 20

Replacing the power supply

Get Lenovo IdeaCentre K230 PDF manuals and user guides View all Lenovo IdeaCentre K230 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Replacing the power supply Attention Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at: http://consumersupport.lenovo.com To replace the power supply: 1. Remove the computer cover. Refer to "Removing the computer cover". Note: For this procedure, it helps to lay the computer on its side. 2. Disconnect the power supply cables from the system board and from all drives. Refer to "Identifying parts on the system board". 3. Remove the four screws that secure the power supply at the rear of the chassis. 4. Lift the power supply out of the chassis. 5. Install the new power supply into the chassis so that the screw holes in the Hardware Replacement Guide 17 31036127 IdeaCentre K_HRG_EN.indd 17 2008.10.20 1:59:34 PM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
17
Hardware Replacement Guide
Replacing the power supply
Attention
Do not remove the computer cover or attempt any repair before reading the
“Important safety information” in the
Safety and Warranty Guide
that was
included with your computer or in the
Hardware Maintenance Manual
(HMM)
for the computer. To obtain copies of the
Safety and Warranty Guide
or
HMM
, go to the Support Web site at:
To replace the power supply:
1.
Remove the computer cover. Refer to “Removing the computer cover”.
Note:
For this procedure, it helps to lay the computer on its side.
2.
Disconnect the power supply cables from the system board and from all
drives. Refer to “Identifying parts on the system board”.
3.
Remove the four screws that secure the power supply at the rear of the
chassis.
4.
Lift the power supply out of the chassis.
5.
Install the new power supply into the chassis so that the screw holes in the
3
036
27 I
aC
t
K
HRG
E
7
2008
0 20
:59:34 PM