Lenovo NetVista Hardware Maintenance Manual (HMM) for IBM NetVista 6826, 8317, - Page 10
Power Management, APM BIOS Mode, Disabled, Automatic Hardware Power Management
View all Lenovo NetVista manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
If NO, continue to 002 . If YES, proceed to 003 . 002 If the Power Management feature is enabled, do the following: 1. Start the Configuration/Setup Utility program (see "IBM Setup Utility program" on page 9) 2. Select Power Management from the Configuration/Setup Utility program menu. 3. Select APM. 4. Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow (}) or Right Arrow (Æ) to change the setting. 5. Select Automatic Hardware Power Management. 6. Set Automatic Hardware Power Management to Disabled. 7. If the problem persists, continue to 003 . 003 Run the Diagnostic programs. If necessary, refer to "Diagnostics" on page 12. v If you receive an error, replace the part that the diagnostic program calls out or go to ″Symptom-to-FRU Index″ on page 37. v If the test stops and you cannot continue, replace the last device tested. 4 Hardware Maintenance Manual