Lenovo R500 Troubleshooting Guide - Page 25
Message, Solution, Exit Saving Changes, Restart - bios
UPC - 884343063324
View all Lenovo R500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Message Solution 0251: System CMOS checksum bad The system CMOS might have been corrupted by an application program. The computer uses the default settings. Run the BIOS Setup Utility to reconfigure the settings. If you still see the same error code, have the computer serviced. 0271: Date and time Neither the date nor the time is set in the computer. Set the error date and time, using the BIOS Setup Utility. 0280: Previous boot Your computer was previously unable to complete the boot incomplete process. Turn the computer off; then turn it on to start the BIOS Setup Utility. Verify the configuration and then restart the computer either by choosing the Exit Saving Changes option under the Restart item or by pressing F10. If you still see the same error code, have the computer serviced. 1802: Unauthorized network card is plugged in - Power off and remove the miniPCI network card. The Mini-PCI network card is not supported on this computer. Remove it. 1803: Unauthorized daughter card is plugged in - Power off and remove the daughter card. The daughter card is not supported on this computer. Remove it. 1804: Unauthorized WAN card is plugged in - Power off and remove the WAN card. The WAN card is not supported on this computer. Remove it. 1805: Unauthorized Wireless USB card is plugged in - Power off and remove the Wireless USB card. The Wireless USB card is not supported on this computer. Remove it. 1830: Invalid The current memory configuration is not supported. If only memory one memory module is installed, it must be in the lower slot, configuration - not in the upper slot. Power off and install a memory module to Slot-0 or the lower slot. Chapter 3. Solving computer problems 17