Lenovo ThinkCentre A50 Hardware Maintenance Manual - Page 70
and/or
View all Lenovo ThinkCentre A50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Diagnostic Error Code 005-031-XXX Video Device Cable failure 005-032-XXX Video Device Controller failure 005-036-XXX Video Register error 005-038-XXX System BIOS extension failure 005-040-XXX Video IRQ failure 005-195-XXX Video Test aborted by user 005-196-XXX Video test halt, error threshold exceeded 005-197-XXX Video test warning 005-198-XXX Video test aborted 005-199-XXX Video test failed, cause unknown 005-2XX-XXX 005-3XX-XXX Video subsystem error 006-000-XXX Diskette interface Test Passed 006-0XX-XXX Diskette interface error FRU/Action 1. Video cable 2. Monitor 3. Video card, if installed 4. System board 1. Video card, if installed 2. System board 1. Video card, if installed 2. System board 1. Video card, if installed 2. System board 1. Video card, if installed 2. System board Information only Re-start the test, if necessary 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 53 2. Re-run test 3. Replace the component called out in warning statement 4. Replace the component under test 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 53 2. Flash the system and re-test. See "Flash update procedures" on page 150 3. Go to "Undetermined problems" on page 88 1. Go to "Undetermined problems" on page 88 2. Flash the system and re-test. See "Flash update procedures" on page 150 3. Replace component under function test 1. Video card, if installed 2. System board No action 1. Diskette drive Cable 2. Diskette drive 3. System board 64 Hardware Maintenance Manual