Lenovo ThinkCentre A50 Hardware Maintenance Manual - Page 72
Signal/Loopback
View all Lenovo ThinkCentre A50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Diagnostic Error Code FRU/Action 011-195-XXX Serial port Test aborted by user Information only Re-start the test, if necessary 011-196-XXX 1. Press F3 to review the log file Serial port test halt, error threshold exceeded 2. Re-start the test to reset the log file 011-197-XXX Serial port test warning 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 53 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 011-198-XXX Serial port test aborted 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 53 2. Flash the system and re-test. See "Flash update procedures" on page 150 3. Go to "Undetermined problems" on page 88 011-199-XXX Serial port test failed, cause unknown 1. Go to "Undetermined problems" on page 88 2. Flash the system and re-test. See "Flash update procedures" on page 150 3. Replace component under function test 011-2XX-XXX Serial port signal failure 1. External serial device 2. System board 014-000-XXX Parallel port Interface Test Passed No action 014-001-XXX Parallel port Presence 1. Remove external parallel device, if present 2. Run setup, enable port 3. System board 014-002-XXX 014-003-XXX Parallel port Timeout/Parity error System board 014-013-XXX 014-014-XXX Parallel port Control Signal/Loopback test failure System board 014-015-XXX Parallel port External Loopback failure 1. Wrap plug 2. System board 014-027-XXX Parallel port Configuration/Setup error 1. Run Setup, enable port 2. Flash the system. See "Flash update procedures" on page 150 3. System board 66 Hardware Maintenance Manual