Lenovo ThinkCentre M77 Hardware Maintenance Manual (HMM) - ThinkCentre M77 - Page 129
Installing or replacing a memory module
View all Lenovo ThinkCentre M77 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
Installing or replacing a memory module Attention: Do not open your computer or attempt any repair before reading and understanding the "Important safety information" in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to: http://support.lenovo.com This section provides instructions on how to install or replace a memory module. Your computer has four slots for installing or replacing DDR3 UDIMMs that provide up to a maximum of 16 GB system memory. When installing or replacing a memory module, use 2 GB or 4 GB DDR3 UDIMMs in any combination up to a maximum of 16 GB. The following table provides information about the memory module installation rules that you should consider when installing or removing a memory module. The "X" mark indicates the memory slot(s) into which the memory module(s) should be installed in different situations. The numbers 1, 2, 3, and 4 indicate the installation sequence. To locate the memory module slots, see "Locating parts on the system board" on page 119. UDIMM One UDIMM Two UDIMMs Three UDIMMs Four UDIMMs DIMM 1 X, 3 X, 3 DIMM 2 X, 4 DIMM 3 X X, 1 X, 1 X, 1 DIMM 4 X, 2 X, 2 X, 2 To install or replace a memory module, do the following: 1. Turn off the computer and disconnect all power cords from electrical outlets. 2. Open the computer cover. See "Opening the computer cover" on page 121. 3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 122. 4. Remove the heat sink fan duct. See "Replacing the heat sink and fan assembly" on page 140. 5. Remove the hard disk drive. See "Replacing the hard disk drive" on page 135. 6. Pivot the optical drive bay upward to gain access to the memory slots. See "Replacing the optical drive" on page 138. 7. Locate the memory slots. See "Locating parts on the system board" on page 77. 8. Remove any parts that might prevent access to the memory slots. 9. Depending on whether you are installing or replacing a memory module, do one of the following: Chapter 9. Replacing FRUs (Machine Types: 1996, 1997, 2002, 2010, 2208, 2209, 2221, 2224, 2226, and 2227.) 125