Lenovo ThinkPad 600 TP 600E On-line User's Guide that was provided with the sy - Page 94
Using Memory Cards, Enter, Drive Letters
View all Lenovo ThinkPad 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
sectors, cylinders, and so on) to use, and then initializes the card. To initialize the card, do as follows: 1 Type the following command: ATAINIT drive_letter: Note: drive_letter is the actual drive letter. For example, if your ATA card has been assigned drive letter D, you should type: ATAINIT D: 2 Press Enter to accept the displayed information. If you want to specify a drive parameter, type P and press Enter. Then follow the instructions in the window. Using Memory Cards For you to use memory cards on your system, your CONFIG.SYS file must contain the following lines (in addition to the standard drivers that are always required): DEVICEHIGH=C:\CARDSOFT\MTSRAM.EXE DEVICEHIGH=C:\CARDSOFT\MTDDRV.EXE Drive Letters You need to know which drive letter to use to access the memory card. Note: Drive letters are shared by memory and Flash memory cards. If you insert a memory card in slot 1, it will be assigned drive E; if you insert a Flash memory card in slot 2, it will use drive F. If you remove the memory card from slot 1, and insert a second Flash memory card in slot 1, it will be assigned drive E, because that is the drive letter assigned to slot 1 for memory and Flash memory cards. Type the following and press Enter: MTDDRV /? Information similar to the following is displayed: 86 IBM ThinkPad 600E Online Book