Lenovo ThinkPad 760CD ThinkPad 380, 385, 560, 560E, all 760, 765 and SelectADo - Page 62

Infrared-Related Symptoms Symptom / Error FRU / Action in Sequence Unable to communicate using the Infrared (IR) Port. 1. Make sure the setup for the IR is correct. 2. Make sure there are no fluorescent lights near the computer. The computer may receive optical noise from the fluorescent light. 3. Run the advanced diagnostic test. If an error occurs and a FRU code is displayed, replace the parts shown by the FRU code. Other Symptoms Symptom / Error Errors occur only when Port Replicator is used. PCMCIA slot pin is damaged. FRU / Action in Sequence See "Port Replicator Checkout" on page 36. PCMCIA Slot Assembly Note: If you cannot find a symptom or error in this list and the problem remains, see "Undetermined Problems" on page 51. Intermittent Problems Intermittent system hang problems can be caused by a variety of reasons that have nothing to do with a hardware defect, such as: cosmic radiation, electrostatic discharge, or software errors. FRU replacement should be considered only when a recurring problem exists. When analyzing the intermittent problem, do the following: 1. Run the advanced diagnostic test for the system board in loop mode at least 10 times. 2. If no error is detected, do not replace any FRUs. 3. If any error is detected, replace the FRU shown by the FRU code. Rerun the test to verify that no more errors exist. 50 IBM Mobile Systems HMM