Lexmark T430 Service Manual - Page 60

4048-1xx Sub error codes First 6 bytes sub error code data (xx can be any value) 84 xx 00 x1 x2 x3 84 xx 01 x1 84 xx 02 x1 x2 84 xx 03 x1 Explanation Possible error message This code indicates that the input sensor 200 is still actuated from the first sheet and the second sheet is ready to arrive at the sensor. (x1=media size, x2=media source.) • Check the printer input sensor and flag for correct operation. The flag should operate freely. • Check for debris in the area of the input sensor. • Check the area of the transfer roll and input to the fuser for anything that might cause the paper to remain over the input sensor. The video signal never started within 2 200 inches after actuating the input sensor. Check input sensor and flag. (x1=media size) Paper is over the input sensor too long. 200 (x1=media size, x2=source.) Possible causes are: • Multi sheet feeding. • Paper size is not the same as expected. • The media feeding from the source is slipping or media is slipping before exiting the input sensor. The measured gap between sheets of 200 media at the input sensor is too small to meet video requirements. x1=time by which the gap was too small. 2-26 Service Manual