Lexmark X852E Setup Guide - Page 9

Step 2: Assemble paper handling options CAUTION: If you are using a 2000-sheet drawer, a duplex unit with one or more input drawers, or more than one 500-sheet drawer, you must use either a printer stand or a caster base. If you purchased a printer stand, follow the assembly instructions provided with the stand, and then return to Step 2: "Assemble paper handling options" in this book. The caster base is used when placing your MFP on the floor. It provides mobility and a stable platform for your MFP. There are different assembly instructions for use with a 2000-sheet drawer, 500sheet drawer, or a 250-sheet drawer. Preparing the caster base CAUTION: The correct stabilizer screws must be installed in each optional drawer and the duplex unit to secure the printer and options together. 1 Remove all items from the caster base carton. 2 Remove and group the machine screws, washers, stabilizer screws, and posts from the hardware bag. 3 Determine which screws you need for your configuration and place the other screws into the bag. • The six long screws (1) are used with three 500-sheet drawers. (two with each 500-sheet drawer) • The six short screws (2) are used with the 2000-sheet drawer or the 250-sheet drawers. • The two long posts (3) are used with the duplex unit. • The two short posts (4) are used when a duplex unit is not available. • The two long machine screws (5) are used with the 2000- sheet drawer. • The two short machine screws (6) are not used with this scanner. Depending on your configuration, some of the stabilizer screws and posts will not be used. 4 If you have a 2000-sheet drawer, place a lock washer and flat washer on each of the two long machine screws (5). Assemble paper handling options 4