LiftMaster 81602 Owners Manual - English French Spanish - Page 24
Wire the Safety Reversing Sensors, FLOOR INSTALLATION
View all LiftMaster 81602 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Install the Protector System® FLOOR INSTALLATION 1. Measure the position of both sensor brackets so they will be the same distance from the wall and unobstructed. 2. Attach the bracket to the floor with concrete anchors (not provided). 3. Slide the hex screw through the sensor. 4. Attach the sensor to the bracket with the wing nut. Make sure the lens is not obstructed by the bracket. Repeat the steps with the other sensor on the opposite side of the garage door. Both lenses must face each other. 1 Inside 2 garage wall Not provided 2 Wire the Safety Reversing Sensors PRE-WIRED INSTALLATIONS: If your garage already has wires installed for the safety reversing sensors, see page 25. OPTION A - INSTALLATION WITHOUT PRE-WIRING 1. Run the wire from both sensors to the garage door opener. Attach with staples, but DO NOT puncture the wire. 2. Separate the sensor wires and strip insulation from each end. Twist the two white wires together. Then twist the two white/black wires together. 3. Using a screwdriver, push in the terminal tabs, and insert the white wires into the white terminal. Insert the white/black wires into the grey terminal. 1 2 Staple Door track 3 4 Wingnut 3 6" (15 cm) max. 7/16" (11 mm) RED WHITE WHITE GREY 24