LiftMaster GH GH LOGIC 3 Manual - Page 18

PROGRAMMING STANDARD SINGLE BUTTON REMOTE CONTROL Built in 3-channel, 315MHz radio receiver allows you to add as many as 23 Security✚® remote controls or dip switch remote controls. PROGRAMMING REMOTE CONTROLS STANDARD SINGLE BUTTON REMOTE CONTROL 1. To enter programming, press and release the RADIO button on the logic board (LED will light). 2. Press and hold the remote control button until the LED flashes rapidly, then release remote control button. The LED will then remain on solid after releasing the button. Repeat to add additional remote control(s). 3. Press and release the RADIO button to complete the programming. The programming mode is exited if no activity is performed within 30 seconds. NOTE: Single button remote control is not supported with D1 and E2 wiring modes. SINGLE BUTTON REMOTE CONTROL PROGRAMMED AS A SINGLE BUTTON CONTROL (SBC) This function programs a remote control as a wireless single button control. This function will work in the following modes: In B2 mode, operation is OPEN/STOP/CLOSE/REVERSE/STOP. In C2 mode, operation is OPEN/STOP/constant pressure to CLOSE/STOP on release. In T and TS modes, operation is OPEN/STOP/CLOSE/ REVERSE/STOP and Timer to Close start/refresh. NOTE: If Car Dealer mode is enabled, SBC will be open only stopping at the Open Mid-Stop. In FSTS mode, operation is OPEN with Timer to Close start/ refresh only, bypassing a programmed Open Mid-Stop. 1. Press and release the RADIO button on the logic board (LED will light). 2. Press and release the SBC externally wired button or TIMER on the logic board (LED flashes rapidly and then remains on solid). 3. Press and hold the remote control button until the LED flashes rapidly. The LED will then remain on solid after releasing. 4. Press and release the RADIO button on the logic board (LED flashes rapidly and then turns off). The programming mode is exited if no activity is performed within 30 seconds. NOTE: Requires self-monitoring photo eyes when using constant pressure to close (wiring C2, D1 and E2 ). ERASING REMOTE CONTROLS Press and hold the RADIO button on the logic board until the RADIO LED flashes rapidly (approximately 5 seconds). All remote controls will be erased. WARNING To prevent possible SEVERE INJURY or DEATH, install reversing sensors whenC: AUTION • The radio is used. • The 3-button control station is out of sight of the door. • Or ANY other control (automatic or manual) is used. Reversing devices are recommended for ALL installations. NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. AVERTISSEMENT ATTENTION P4 E1 R29 C11 D3Ø2 K3 Ø14LGØ6 X1 C54 U1 C71 C78 ® RADIO OLS D25 MID D24 ADVERTENCIA D16 SLS D26 CLS D27 P7 PRECAUCIÓN RADIO MRT MID T 1 2 D36 RELA L i f t M a s t e r C77 C73 L1 L5 RELA D35 E2 D1 C2 B2 FAILSAF P6 REV 18