LiftMaster GH GT- Logic 4 Installation Manual - Page 30

PROGRAMMING REMOTE CONTROLS WARNING To prevent possible SEVERE INJURY or DEATH: CAUTION • Install a LiftMaster Monitored Entrapment Protection (LMEP) • Activate door ONLY when it can be seen clearly, is properly device. adjusted and there are no obstructions to door travel. • NEVER permit children to operate or play with door control • ALWAYS keep door in sight until completely closed. NEVER push buttons or remote controls. permit anyone to cross the path of closing door. W W Built in 3-channel, 315 MHz radio receiver allows you to add as many as 23 Security® remotes or dip switch remote controls. NOTE: The following programming requires a LiftMaster Monitored Entrapment Protection (LMEP) device. NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. STANDARD REMOTE CONTROL 1. To enter programming press and release the RADIO button on the logic board (RADIO LED will light). AVERTISSEMENT 2. Press and hold the remote control button until the RADIO LED flashes rapidly, then release remote control button. The RADIO LED will then remain on solid after releasing the button. Repeat to add additional remote control(s). ATTENTION 3. Press and release the RADIO button to complete the programming. The programming mode is exited if no activity is performed within 30 seconds. AVER AVE SINGLE BUTTON REMOTE CONTROL PROGRAMMED AS A SINGLE BUTTON CONTROL (SBC) This function programs a remote control as a wireless single button control. This function will work in the following modes: In B2 mode, operation is OPEN/STOP/CLOSE/REVERSE/STOP. In T and TS modes, operation is OPEN/STOP/CLOSE/REVERSE/ STOP and Timer-To-Close start/refresh. NOTE: If Car Dealer mode is enabled, SBC will be open only stopping at the Open Mid-Stop. In FSTS mode, operation is OPEN with Timer-To-Close start/refresh only, bypassing a programmed Open Mid Stop. RADIO 1. Press and release the RADIO button on the logic board (RADIO LED will light). ADVERTENCIA 2. Press and release the SBC externally wired button or TIMER on the logic board (RADIO LED flashes rapidly and then remains on solid). PRECAUCIÓN 3. Press and hold the remote control button until the RADIO LED flashes rapidly. The RADIO LED will then remain on solid after releasing. 4. Press and release the RADIO button on the logic board (RADIO LED flashes rapidly and then turns off). The programming mode is exited if no activity is performed within 30 seconds. NOTE: Single button remote control is not supported with D1 and LiftMaster E2 wiring modes. C2 mode will only open and stop while opening. ERASING REMOTE CONTROLS Press and hold the RADIO button on the logic board until the RADIO LED flashes rapidly (approximately 5 seconds). All remote controls will be erased. SLOT 2 SLOT 1 REV MOTOR STD DIRECTION OLS MID SLS CLS MRT MID RADIO 1 2 T TS E2 D1 C2 B2 RELAY A RELAY B ADV AD PROGRAMMING 30 Programming - Remote controls