LiftMaster Readers User Guide - Page 6
Program Cards And Pins., General Programming Information, Add Or Delete A Pin, Change A Pin
View all LiftMaster Readers manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
PROGRAMMING 5 Program Cards and PINS. Programming will vary depending on the access configuration. Follow the instructions according to your access configuration. GENERAL PROGRAMMING INFORMATION • User ID Number: Assign a user ID number to the access code in order to keep track of the users of access cards or PINs. The user ID number can be any number from 1~2000. IMPORTANT: User IDs do not have to be proceeded with any leading zeros. Recording of User ID is critical. Modifications to user data require either the card or the User ID be available. • Proximity Card: Any 125 KHz industry standard 26 bit Wiegand Proximity Card. • Keypad PIN: The PIN can be any 4~8 digits between 0000~99999999 (except 1234 which is reserved for factory testing). IMPORTANT: PINs less than 1000 must be preceded with leading zeros. PINs greater than 9999 do not require any leading zeros. ADD USER CARD(S) ACCESS CONFIGURATION: CARD OR PIN & CARD ONLY ADD OR DELETE A PIN Programming Step Keystroke Combination 1. Enter Program Mode ✱ (Master Code) # 2. Add Card: Using Auto ID (Allows KPR2000 to assign Card to next available User ID number) OR 2. Add Card: Select Specific ID (Allows manager to define a specific User ID to associate the card to) OR 2. Add Card: Block Learn (Allows manager to add up to 2000 cards to the KPR2000 in a single step †). Takes 2 minutes to program. 1 (Read Card) # Repeat Step 2 for additional user cards 1 (User ID) # (Read Card) # 5 (User ID) # (The first card number) # (Card Quantity) # Card quantity = number of cards to be enrolled 3. Exit Program Mode ✱ Programming Step Keystroke Combination 1. Enter Program Mode ✱ (Master Code) # 2. Add a PIN Assigns PIN to user ID number OR 2. Delete a PIN Deletes the User ID number and associated PIN 1 (User ID) # (PIN) # Repeat Step 2 for additional PINs 2 (User ID) # Repeat Step 2 for additional PINs 3. Exit Program Mode ✱ CHANGE A PIN This operation is executed from outside of Program Mode. Programming Step 1. Change a PIN Keystroke Combination ✱ (User ID) (Old PIN #) (New PIN #) (New PIN #) DELETE USER CARD(S) Programming Step 1. Enter Program Mode 2. Delete Card - By User ID OR 2. Delete Card - By Card OR 2. Delete Card -By Card Number 3. Exit Program Mode Keystroke Combination ✱ (Master Code) # 2 (User ID) # Deleting by User ID number will clear cards and PINs 2 (Read Card) # Requires the user card. Deletes ONLY the card number 2 (Card Number) # Deletes ONLY the card number † ✱ † BLOCK LEARN DIRECT ENTRY Format for programming specific Card Numbers: Facility Code + ID Number (including leading 0's) Example: FAC- 24, ID- 100 would be entered as: 26 Bit: 02400100 30 Bit: 002400100 6