LiftMaster Readers User Guide - Page 7

PROGRAMMING ACCESS CONFIGURATION: CARD ONLY USING MANAGER CARDS KPR2000 managers can use manager cards to program user cards into and out of the system. There are two pre-programmed manager cards (an Add Card, and a Delete Card) to allow rapid card enrollment. This is a form of Auto User ID enrollment and is only available in "Card Only" configuration. Programming Step Keystroke Combination Add a User Card 1. (Read Manager Add Card) 2. (Read User Card) Repeat Step 2 for additional user cards 3. (Read Manager Add Card) Delete a User Card 1. (Read Manager Delete Card) 2. (Read User Card) Repeat Step 2 for additional user cards 3. (Read Manager Delete Card) ACCESS CONFIGURATION: CARD + PIN ADD A CARD + PIN USER Programming Step 1. Enter Program Mode 2. Add a User Card Assigns card number to User ID 3. Exit Program Mode 4. Add PIN Keystroke Combination ✱ (Master Code) # 1 (Read Card) # OR 1 (User ID) # (Read Card) # ✱ ✱ (Read Card) (1234#) (New PIN #) (New PIN #) This operation is executed from outside of Program Mode CHANGE PIN Allows card user to update the PIN for their card + PIN User ID. This operation is executed from outside of Program Mode. Programming Step Keystroke Combination 1. Change PIN using a Card ✱ (Read Card) (Old PIN #) (New PIN #) (New PIN #) OR 1. Change PIN using PIN ✱ (User ID) (Old PIN #) (New PIN #) (New PIN #) DELETE CARD BY USER ID Deleting by ID number will clear cards and PINs. Programming Step 1. Enter Program Mode 2. Delete User Card by User ID 3. Exit Program Mode Keystroke Combination ✱ (Master Code) # 2 (User ID) # ✱ ADVANCED PROGRAMMING Panic Codes There is a section of the KPR2000 memory set aside specifically for cards and PINs to be used in the instance of an emergency. There are several rules that guide the use of these cards/PINs: • Panic Codes activate the relay and the alarm/alarm output. • Panic Codes use a User ID of 2001~2010 ONLY. • Panic Codes must be unique. Duplicated Codes act as a normal User Code. ADD OR DELETE A PANIC PIN ADD OR DELETE A PANIC CARD Programming Step Keystroke Combination Panic PIN Codes: Add or Delete a PIN 1. Enter Program Mode ✱ (Master Code) # 2. Add a PIN OR 2. Delete a PIN 8 (User ID Number) # (PIN) # 2 (User ID Number) # 3. Exit Program Mode ✱ Programming Step 1. Enter Program Mode 2. Add a User Card OR 2. Delete a User Card 3. Exit Program Mode Keystroke Combination ✱ (Master Code) # 8 (User ID Number) # (Card) # 2 (User ID Number) # ✱ 7