Mackie Onyx 1640i Owner's Manual - Page 29

Appendix B: Connections "XLR" Connectors Mackie mixers use 3-pin female "XLR" connectors on all microphone inputs, with pin 1 wired to the grounded (earthed) shield, pin 2 wired to the "high" ("hot" or positive polarity) side of the audio signal and pin 3 wired to the "low" ("cold" or negative polarity) side of the signal. See Figure A. Use a male "XLR"-type connector, usually found on the nether end of what is called a "mic cable," to connect to a female XLR jack. SHIELD 2 HOT COLD 3 1 SHIELD 1 • Unbalanced Send/Return circuits. When wired as send/return "Y" connector, a 1⁄4" TRS jack or plug is connected tip to signal send (output from mixer), ring to signal return (input back into mixer), and sleeve to ground (earth). 1⁄4" TS Phone Plugs and Jacks "TS" stands for Tip-Sleeve, the two connections available on a "mono" 1⁄4" phone jack or plug. See Figure C. TS jacks and plugs are used in many different applications, always unbalanced. The tip is connected to the audio signal and the sleeve to ground (earth). Some examples: Figure A: XLR Connectors COLD 3 2 HOT 1 3 2 SHIELD COLD HOT SLEEVE TIP SLEEVE TIP TIP SLEEVE 1⁄4" TRS Phone Plugs and Jacks "TRS" stands for Tip-Ring-Sleeve, the three connections available on a "stereo" 1⁄4" or "balanced" phone jack or plug. See Figure B. TRS jacks and plugs are used in several different applications: Figure C: TS Plug • Unbalanced microphones • Electric guitars and electronic instruments • Unbalanced line-level connections • Speaker connections Don't use guitar cords for speaker cables! They're not designed to handle speaker-level signals and could overheat. RING SLEEVE SLEEVE RING TIP TIP Figure B: 1⁄4" TRS Plugs RING TIP SLEEVE • Balanced mono circuits. When wired as a balanced connector, a 1⁄4" TRS jack or plug is connected tip to signal high (hot), ring to signal low (cold), and sleeve to ground (earth). • Stereo Headphones, and rarely, stereo microphones and stereo line connections. When wired for stereo, a 1⁄4" TRS jack or plug is connected tip to left, ring to right and sleeve to ground (earth). Mackie mixers do not directly accept 1-plug-type stereo microphones. They must be separated into a left cord and a right cord, which are plugged into two mic preamps. RCA Plugs and Jacks RCA-type plugs (also known as phono plugs) and jacks are often used in home stereo and video equipment and in many other applications (Figure D). They are unbalanced and electrically identical to a 1⁄4" TS phone plug or jack. See Figure C. Connect the signal to the center post and the ground (earth) or shield to the surrounding "basket." SLEEVE TIP SLEEVE TIP Figure D: RCA Plug Figure E: Does not appear in this owner's manual, due to a contractual obligation, but performs nightly at the downtown Woodinville Cocoa Rooms and Tea Bar Owner's Manual 29