Magnavox 40MF401B Owners Manual - Page 12

12 WATCHING TV Sleep Timer can set the unit to go into standby mode after an incremental period of time. Press SLEEP repeatedly to change the amount of time (increases Sleep the time by 30 minutes up to 120 minutes). Press SLEEP once to call up the display for checking the remaining time. • To cancel sleep timer, press SLEEP repeatedly until [Sleep Off] is displayed. 120min. Switching Each Input Mode can easily switch with the remote control between TV (ATSC or NTSC) and external devices when they are connected to the unit. Press SOURCE or CH + repeatedly to cycle through the input modes. Source TV HDMI1 e.g.) 11.1 HDMI1 HDMI2 HDMI2 HDMI3 DTV /TV channel (or PC Input) Component Video1 Video2 Video1 Video2 • Pressing CH − reverses the direction of the input modes. HDMI3 Component Freeze Mode can freeze the image shown on the TV screen for 5 minutes. Press FREEZE to freeze the image. Freeze • The sound output will not be paused. • To cancel freeze mode, press any buttons except . Channel Selection Select channels by using CH +/− or the Number buttons. • To select the memorized channels, use CH +/− or the Number buttons. • To select the non-memorized channels, 11.1 use the Number buttons. To use the Number buttons ATSC - When selecting digital channel 11.1 Be sure to press • before entering the subchannel number. NTSC - When selecting cable or analog channel 11 Press PREV CH to return to the previously viewed channel. Note • [No Signal] will appear on the TV screen after the subchannel broadcast is over. • [Audio only program] message will appear on the TV screen, when you receive only sound signal.