Magnavox 50MV336X/F7 Owners Manual English - Page 17

These Operations are accessible by Remote Control. Some may also be accessible by the Main Unit's Control Panel. Initial Setup This section will guide you through the Unit's Initial setting which includes selecting a Language for your On-screen Menu, country, location and Autoprogram, which Automatically scans and memorizes viewable channels. You can also set the network connection in this setting. Before you begin: Make sure the Unit is connected to an Antenna or Cable. 1 After making All the Necessary Connections, press B to Turn On the Unit. ● It may take a few moments to Turn On the Unit for the first time. ● Initial setup menu appears Automatically after the Unit is Turned On. 2 Use H I to Select the on-screen language, country, TV placement and location in the middle of the TV screen, then press OK. ● You must set Home in location setting. Otherwise, Picture and Sound settings you adjusted will not be memorized after the Unit goes into Standby mode. 3 Use J K to Select Skip or Next on Network setup screen. 4 Use H I to Select Wireless or Wired, then press OK. Installation This TV can be connected to your home network. Select your connection type. Wireless Wired 12 34 Skip 567 Wireless Wired If you have a Wireless Router, select Wireless to connect to the Internet. If you connect with an Ethernet Cable, select Wired to connect to the Internet. ● If you have a router with easy connect function, select Wireless and use H I to Select Simple Connect, then press OK. 5 Follow the on-screen instructions to complete the installation. ● When you select On in the selection screen for Auto software update, A message will appear later if there is the latest software on the network server. 17 .English 6 Use H I to Select the signal type. ● If the TV is connected to a Cable or Satellite Set-top Box, select the 2nd one and skip to step 8. Installation Select "Antenna" to set up a TV signal from a cable TV wall jack or a standard TV antenna. Antenna Set-top box Select "Set-top box" to set up a TV signal from a cable TV box or satellite TV receiver. 12 34 56 7 7 Use H I to Select Antenna for TV channels or Cable for CATV channels, then press OK. Installation Make sure that you have attached your antenna or cable signal into the jack on the back of your TV labeled "ANTENNA IN". Antenna Cable Skip Now select either Antenna or Cable, using up/down key of the remote control. Once you have made your selection, press the OK button to 12 34 56 proceed. 7 - When Antenna is selected, the TV detects Antenna signals. It searches for DTV and Analog TV channels available in your area. - When Cable is selected, the TV detects signals supplied by cable. It searches for DTV, Analog TV and Cable channels available in your area. ● Auto programming will begin. Installation System searching. Please wait... Auto programming may take more than 20 minutes to complete. Digital channels will take longer than Analog to find and program. Please wait until you see the Auto Programming complete message. Digital channels found: Analog channels found: Total progress: 12 34 56 Stop 0 0 7 Continued on next page.