Magnavox MFX450 User manual, English (US) - Page 17

MFX450_eng 11/26/02 3:21 AM Page 16 English DISPLAY Display The display of the receiver is divided into 4 sections, which are to be used for the following: Status lights Speaker diagram Signs show you various settings and information about the status of the receiver. A rectangle with a letter in it shows that a speaker has been selected in the setup menu. However, the subwoofer indicator will only light when a subwoofer signal is available. If only a letter is shown, this speaker is not used and its sound is being reproduced by the other speakers. .....virtual surround sound SURROUND surround sound is reproduced DIGITAL SURROUND ....digital surround sound is reproduced L, R front left and right speaker C center speaker SL, SR surround speakers SW subwoofer Menu indication These signs show you if the menu is on or off and indicate in which direction you may move. PRESET Tuner is tuned to a preset radio station. SENS HI Tuner is switched to high sensitivity. SENS LO Tuner is switched to low sensitivity. CINEMA LINK ON ......CINEMA LINK is active STEREO An FM station is being received in stereo. SMART SOUND ...........One of the preset sound settings of the receiver is being used. HALL HALL effect is on. ANA Analog input is being used for the playing source. NIGHT NIGHT MODE is on. COAX 1 Coaxial digital input COAX 1 is being used for the playing source. COAX 2 Coaxial digital input COAX 2 is being used for the playing source. DOWNMIX Incoming multichannel signals are being reduced to fewer output signals (depending on the number of speakers). OPT Optical digital input OPTICAL IN is being used for the playing source. LOUDNESS LOUDNESS is switched on. Information area MENU Menu is on. 1 You may move backwards to the previous menu topic using 1 PREV. / EXIT ("left" key on the remote control). 3 You may move up in an option list using X MENU NAVIGATOR ("up" key on the remote control). 4 You may move down in an option list using X MENU NAVIGATOR ("down" key on the remote control). 2 You may move forward to the next menu topic using NEXT 2 ("right" key on the remote control). OK You may confirm the displayed value. This area is used for feedback of the receiver, tuner frequencies, menu options, values and scrolling text messages. 16