Makita EK7651H Owners Manual - Page 22
Changing the cutting attachment position
View all Makita EK7651H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Mounting direction A B Fig. 1 Tension adjustment screw Hex. nuts End of screw Belt cover Hood Fig. 2 Changing the cutting attachment position (central/side) Mounting direction of hood • The Power Cutter's cutting attachment is mounted in the direction shown in Fig. A. If desired, use the following procedure to mount it in the direction shown in Fig. B. Mounting in direction B (1) Loosen tightening nut, and turn tension adjustment screw to the left until the end of the screw is visible. (Fig. 1) (2) Remove tightening nuts and remove belt cover. (Fig. 1) (3) Rotate the hood to the broken line position. Remove V-belt and then remove cutting attachment from the Power Cutter. Reposition the grip. (Fig. 2) (4) Pick up the lock shaft with a slotted screwdriver or a plier. (Fig. 3) (5) Rotate the arm until it contacts the grip and return the lock shaft to the original position by hand. (Fig. 4) Reposition the grip. (Fig. 5) (6) Turn over the removed cutting attachment, pass bolt through hole, and remount in direction B. Remount the V-belt to the pulley. (Fig. 6) (7) Mount belt cover. (Fig. 7) Turn the tension adjustment screw to adjust the tension of the V-belt. Once tension adjustment is finished, firmly tighten the tightening nut. Plier V-belt Fig. 3 Lock shaft Arm Fig. 4 Grip Relocate Bolts Grip Fig. 5 V-belt Holes Belt cover Pulley Bolts Fig. 6 22 Belt cover Hex. nut Fig. 7