Marantz PMD340 User Guide - Page 19

ENGLISH ENGLISH FRANCAIS FRANCAIS ESPANOL ESPANOL Synchro Recording Using Synchro Recording This CD player has a CD SYNC function that makes it easy to record for this CD player to be used in combination with a cassette recorder. - The CD SYNC function works in combination with a cassette deck that is equipped with the synchro recording function. - Connect the remote control jack (RC5) output b on this CD player to the (RC5) input on the cassette deck, and then prepare the cassette deck for synchro recording. Refer to figure 2 for the connection method. Procedure 1. Put the cassette recorder into the synchro recording mode. 2. With the CD player in the stopped state, press the button !7 to start playing the CD. The cassette recorder automatically begins recording. 3. When the CD player finishes playing, it stops and the cassette recorder enters the paused state. 4. To continue recording, repeat this procedure, starting from step 2. Tips: - When performing synchro recording with a non-cassette recorder, such as a CD-R or CD-RW recorder, the operation may differ, so check the instruction manual provided with your recorder. - When performing synchro recording, set preset menu No.17 "CD sync" to "On". - Make sure to set preset menu item No.1 "Auto Cue" to "Off" and No.13 "Start" to "Play" or "Stop" before utilizing CD Sync function. ( See also page 17.) Using a Remote Control (Not Included) - This CD player can receive signals directly from an infrared remote control transmitter within about 5 meters (15 feet.) Note that the CD player might not operate correctly if the remote control transmitter is not pointed in the direction of the sensor on the CD player, or if there is an obstacle between the transmitter and the sensor. Area where an infrared remote control transmitter can be used Approximately 5 meters ໿N (15 feet) IR CD PLAYER POWER ˃ HEADPHONE LEVEL MIN MAX 60° TIME 1 TEXT 2 6 3 7 4 8 5 9 PROG 0 PRESET MODE - INDEX END + A-B PITCH - ON/OFF PITCH BEND + CLEAR ENTER CONTRAST PITCH / SEARCH Infrared remote cont੺ro֎lઢtϦraϞnίsϯmૹi৴tt‫ػ‬er CD player (This unit) The figure depicts the PMD331/PMD340. PORTUGUES PORTUGUES DEUTSCH DEUTSCH ITALINO ITALINO NEDERLANDS NEDERLANDS SVENSKA SVENSKA - This CD player can be controlled through its infrared sensor @9 on the front panel when it receives remote control signals that supports RC5 signals as shown in the table at right. These remote control codes can also be used if sent through the RC5 remote control jack b found on the rear panel of the CD player. Tip: Because the infrared remote sensor @9 on the front panel of the CD player and the RC5 remote control input jack on the rear panel of the CD player both support the RC5 codes listed in the table at right, this CD player can be controlled through the infrared remote control sensor of any device that supports RC5 codes. * Remote control codes that are marked with an asterisk are not supported by the PMD330. 15 INPUT 3$
$PEF
DIBSU Command Play Pause Cue Stop FF FR(REW) Index + Index Next Previous Pitch + Pitch Pitch Bend + Pitch Bend A - B Program Pitch On/Off Open/Close Time Cord 2053 2048 2059-10 2054 2052 2050 2034 2035 2032 2033 2038 2039 2038-10* 2039-10* 2059 2041 2037 2045 2011 OUTPUT INPUT Command Mode Preset END monitor CD-TEXT 0 1 2 3 4 5 6 7 8 9 CD Sync start CD Sync stop Cord 2036-10 2041-12 2043-10 2088 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 1856 1857 DANSK DANSK