Marantz SA-10 All-new SACD-M3 transport mechanism for CD SACD and mor - Page 25
Specifying the desired sound, quality
View all Marantz SA-10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Overview Connections Connect and playback from a digital device (Coaxial/Optical) 1 Press DISC/INPUT to switch the playback media mode to "Coaxial" or "Optical". The digital audio signal that is being input is shown as follows in the display. "Coax:xxxxk" or "Opt:xxxxk" (xxxx is the sampling frequency.) 0 If the sampling frequency cannot be detected, "Unlock" will be displayed. 0 "Unsupported" is displayed when audio signals that are not supported by this unit are input. n Specifications of supported audio formats See "D/A converter" (v p. 39). Specifying the desired sound quality Switching the filter characteristics This unit is equipped with a sound quality adjusting function which allows users to enjoy the desired playback sound quality. The unit supports PCM signal. The 2 filter characteristics types are explained below. Filter Type Characteristic Filter 1 Very short but symmetrical impuls response. Very precise soundstage and smooth tonal balance. Filter 2 Very short pre-ringing - long post-ringing. Phase compensated analog filter. Neutral tonal balance - slightly brighter than "Filter1". NOTE 0 Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise and could damage the speakers. ENGLISH 1 Press FILTER The setting cycles through the 2 modes (Filter 1 / Filter 2) as shown below each time the button is pressed. NOTE 0 The filter characteristics have a last memory function. These settings remain in memory even if a disc change occurs, or if the power is turned off. 0 The filter function does not work during playback of Super Audio CDs or DSD audio sources. Playback Settings Tips Appendix 24