Marantz SR4003 SR4003 User Manual - Englis - Page 14
Connecting Audio Components
View all Marantz SR4003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
NAMES AND FUNCTIONS BASIC CONNECTIONS BASIC OPERATION CONNECTING AUDIO COMPONENTS CD recorder DIGITAL OUTPUT DIGITAL INPUT OUT IN DIGITAL OUTPUT L L R R CD player OUT IN L L R R LR LR Tape Deck L R R L RL LR VIDEO FM (75Ω) GND AM ANTENNA L SL C L S-VIDEO TV SBL R R SR SW SBR (AUX 2) 7.1CH INPUT TV INPUT 1 INPUT DVD VCR IN VCR OUT DSS MONITOR OUT 2 Y CB/PB CR/PR Y DVD IN OUT VCR DSS AUDIO IN OUT TAPE IN OUT CD/CDR CB/PB INPUT 3 COMPONENT VIDEO MONITOR OUT CR/PR IN 3 4 INPUT 1 1 2 DIGITAL IN OPT OUT FLASHER DIGITAL OUT REMOTE CONT. IN INPUT 2 INPUT 3 OUTPUT L SL C SBL R L R L R L AC OUTLETS 120V 60Hz AC IN R SR SW SBR PRE OUT FRONT SURROUND BACK S. SPEAKER B SURROUND SPEAKER SYSTEMS : 6-8 OHMS CENTER SWITCHED 1.25A 150W MODEL NO. SR4003 RL RL ENGLISH The output audio signal from the TAPE OUT jack and the CD/CD-R OUT jack is the same signal which is currently selected. Caution: Do not connect this unit and other components to mains power until all connections between components have been completed. Notes: • Insert all plugs and connectors securely. Incomplete connections may make noise. • Be sure to connect the left and right channels properly. Red connectors are for the R (right) channel, and white connectors are for the L (left) channel. • Be sure to connect input and output properly. • Refer to the instructions for each component that is connected to this unit. • Do not bind audio/video connection cables with power cords and speaker cables this will result in generating a hum or other noise. CONNECTING DIGITAL AUDIO COMPONENTS • There are 4 digital inputs, 2 coaxial jacks and 2 optical jacks, on the rear panel. You can use these jacks to input PCM, Dolby Digital and DTS bitstream signals from a CD, DVD, or other digital source components. • There is one optical output jack on the rear panel. These jacks can be connected to a CD recorder, or a MD deck inputs, respectively. • Refer to the instructions for each component. To setup the digital audio format of DVD player, or other digital source's connected to digital input jacks. • Use fiber optical cables (optical) for DIG-1,2, input jacks. Use 75 ohms coaxial cables (for digital audio or video) for DIG-3,4, input jacks. • You can designate the input for each digital input/ output jacks according to your component. See page 21. Notes: • There is no Dolby Digital RF input jack. Please use an external RF demodulator Dolby Digital decoder when connecting the Dolby Digital RF output jack of the video disc player to the digital input jack. • The digital signal jacks on this unit conform to the EIA standard. If you use a cable that does not conform to this standard, this unit may not function properly. • Each type of audio jack works independently. Signals input through the digital and analog jacks are output through the corresponding digital and analog jacks, respectively. LR Analog Audio Digital Audio (coaxial) Digital Audio (optical) ADVANCED CONNECTIONS SETUP ADVANCED OPERATION TROUBLESHOOTING OTHERS 11