Marantz SR4003 SR4003 User Manual - Englis - Page 38

NAMES AND FUNCTIONS BASIC CONNECTIONS BASIC OPERATION LEARN MODE This remote controller is capable of learning and storing codes used by other remote controls that you already own. For codes which are not learned, the remote controller will transmit either the Marantz preset codes from the initial settings, or remote codes from another manufacturer's AV equipment which is set by the customer. The receiver sensor for the remote controller signals is located at the top of the remote controller. Notes: • This remote controller is capable to learn around 60 codes. • When the batteries are getting weak , the learning procedure is not successful. LEARNING PROCEDURE 1. Place the remote controller so that its infrared signal transmitter is facing the infrared signal receiver on the Marantz remote controller at a distance of about 0.05 m (2 inches). 0.05 m 4. Select the button to be learned. • LEARN indicator lights up. ERASING PROGRAMMED CODES (RETURNING TO INITIAL SETTINGS) Notes: Codes can be erased in three ways: by buttons, sources, and by all memory contents. • The learning function is unavailable for all SOURCE buttons and HDMI button in any mode. Erasing the code by buttons • The learning function is unavailable for all buttons 1. Press and hold down the SET and SETUP in TUNER mode and AMP mode. buttons until LEARN indicator blinks. 5. Press and hold the button of the original remote controller to learn until the SEND indicator blinks twice. Notes: • When the SEND indicator blinks once, repeat this step. 2. Select the SOURCE button to select the button • If the LEARN indicator flashes when the SEND to be erased. indicator is lit, then the button cannot be learned. • When the memory of the remote controller is full, the LEARN and SEND indicators blink once. If you want to learn the code, you should erase other learned button. 6. Repeat steps 4 and 5 to learn other buttons in same SOURCE. 3. Press and hold down the HDMI button and 7. Repeat steps 3 to 6 to learn other SOURCE. press the learned button twice to be erased. 8. When you have finished programming the remote controller, press the SET button, then • SEND indicator blinks twice and the mode returns to LEARN mode. LEARN indicator stops blinking and exits from the LEARN mode. ENGLISH 3. Press ENTER button to continue erasing. • The SEND indicator blinks twice and the mode returns to LEARN mode. • To cancel the erasing operation, do not press ENTER button and simply touch any other button. 4. To return the NORMAL mode, press the SET button. Erasing the all SOURCES 1. Press and hold down the SET and SETUP buttons until LEARN indicator blinks. 2. Press and hold down the HDMI button and press POWER ON and POWER OFF button. • LEARN indicator lights. ADVANCED CONNECTIONS SETUP ADVANCED OPERATION TROUBLESHOOTING 2. Press and hold down the SET and SETUP buttons until LEARN indicator blinks. 3. Select the SOURCE button to select the SOURCE. Notes: 4. To return the NORMAL mode, press the SET button. • When the SEND indicator blinks once again, Erasing the code by SOURCE the transmitting code is unavailable for remote controller, or the transmitting signal is intercepted 1. Press and hold down the SET and SETUP by noise. buttons until LEARN indicator blinks. • If no buttons are pressed for approximately 1 minutes while in the LEARN mode, the remote controller automatically exits from the LEARN mode. 2. Press and hold down the HDMI button and press the learned SOURCE button twice to be erased. • LEARN indicator lights. 3. Press ENTER button to continue erasing. • The SEND indicator blinks twice and the mode returns to LEARN mode. • To cancel the erasing operation, do not press ENTER button and simply touch any other button. 4. To return the NORMAL mode, press the SET button. Note: Erasing codes will return to the factory preset code, or there will leave empty if the button has no factory preset code. 35 OTHERS