Marantz SR5001 Marantz AV Receiver IR Remote Code List - Page 10
Rear Panel - xm
View all Marantz SR5001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
ENGLISH REAR PANEL SR4001 w !1 qt r !3 !8 !6 VIDEO INPUT 1 FM (75Ω) GND AM ANTENNA L SL C L S-VIDEO TV SBL DVD INPUT VCR IN VCR OUT DSS/VCR2 MONITOR OUT 2 Y CB/PB CR/PR INPUT 3 MONITOR OUT COMPONENT VIDEO Y CB/PB CR/PR 3 4 COAX IN HDMI Ver 1.1 INPUT 1 INPUT 2 OUTPUT R R SR SW (AUX2) 7.1CH INPUT SBR L SL C SBL R SR SW SBR PRE OUT IN OUT IN IN OUT IN OUT TV DVD VCR1 DSS/VCR2 CD TAPE CDR/MD AUDIO 1 2 DIGITAL IN R L R L R L FRONT SURROUND BACK S. SPEAKER B SURROUND SPEAKER SYSTEMS : MINIMUM 6 OHMS CENTER OPT DIGITAL OUT OUT RC-5 FLASHER IN UNSWITCHED 1.25A 150W AC IN SWITCHED 1.25A 150W AC OUTLETS 120V 60Hz MODEL NO. SR4001 y !0 !4 o !5 i u SR5001 !1 w !2 q t r !8 !6 @0 VIDEO INPUT 1 FM (75Ω) GND AM ANTENNA L SL C L S-VIDEO TV SBL DVD INPUT VCR IN VCR OUT DSS/VCR2 MONITOR OUT 2 Y CB/PB CR/PR INPUT 3 COMPONENT VIDEO MONITOR OUT 2 Y CB/PB CR/PR Y CB/PB CR/PR 3 4 COAX IN HDMI Ver 1.1 INPUT 1 INPUT 2 OUTPUT XM R R SR SW (AUX2) 7.1CH INPUT SBR MULTI. OUT TV RS-232C SPEAKER C OFF ON DVD IN OUT IN VCR1 DSS/VCR2 IN OUT CD TAPE AUDIO IN OUT CDR/MD 1 2 3 OPT OUT DIGITAL IN DIGITAL OUT RC-5 FLASHER DC IN TRIGGER UNSWITCHED 1.25A 150W L SL C SBL R L R L R L R L AC IN FRONT B FRONT A SURROUND BACK SURROUND CENTER R SR SW SBR FRONT A OR B,CENTER, SPEAKER C/MULTI SPEAKER SPEAKER FRONT A AND B:MINIMUM 8 OHMS SURR,SURR BACK:MINIMUM 6 OHMS SYSTEMS PRE OUT SWITCHED 1.25A 150W AC OUTLETS 120V 60Hz MODEL NO. SR5001 e y !0 !9 o !4!5 i !3 u !7 q VIDEO IN/OUT (TV, DVD, VCR1, DSS/ VCR2) These are the video inputs and outputs. There are 4 video inputs and 2 video outputs and each one includes both composite video and S-video configurations. Connect VCRs, DVD players, and other video components to the video inputs. The 2 video output channels can be used to be connected to video tape recorders for making recordings. The input signals of video and S-video are converted each other, and each of the converted video signals can be output. w FM antenna terminal (75 ohms) Connect an external FM antenna with a coaxial cable, or a cable network FM source. AM antenna and ground terminals Connect the supplied AM loop antenna. Use the terminals marked "AM" and "GND". The supplied AM loop antenna will provide good AM reception in most areas. Position the loop antenna until you hear the best reception. e RS-232C (SR5001 only) The RS-232C port is to be used in conjunction with an external controller to control the operation of the SR5001 by using an external device. r COMPONENT VIDEO INPUT/ OUTPUT If your DVD player or other device has component video connectors, be sure to connect them to these component video connectors on the SR4001/ SR5001. The SR4001/SR5001 has two component video input connectors to obtain the color information (Y, CB, CR) directly from the recorded DVD signal or other video component and one component video output connector to output it directly into the matrix decoder of the display device. By sending the pure DVD component video signal directly, the DVD signal forgoes the extra processing that normally would degrade the image. The result is vastly increased image quality, with incredibly life like colors and crisp detail. When the video convert function is enabled, video and S-video images can be output to the COMPONENT MOINTOR OUT jack. t MONITOR OUT This is a monitor output and each one includes both composite video and S-video configurations. When connecting two video monitors or televisions, be aware that the OSD interface can be used with both MONITOR OUT connections. y Preamp Outputs (L, R, SL, SR, SBL, SBR, C) Jacks for L(front left), R (front right), C (Center), SL (surround left), SR (surround right), SBL (surround back left) and SBR (surround back right). Use these jacks for connection to external power amplifiers. u AC INLET Plug the supplied power cord into this AC INLET and then into the power outlet on the wall. SR4001/SR5001 can be powered by 120V AC only. i AC OUTLETS Connect the AC power cable of component such as a DVD or CD player to this outlet. The marked SWITCHED provides power only when the SR4001/SR5001 is turned on and is useful for components which you use every time you play your system. Caution: • In order to avoid potential turn-off thumps, anything plugged into these outlets should be powered up before the SR4001/SR5001 is turned on. • The capacity of this AC outlet is 150W. Do not connect devices that consume electricity more than the capacity of these AC outlet. If the total power consumption of the connected devices exceeds the capacity, the protection circuit shuts down the power supply. o Speaker outputs terminals Seven terminals are provided for the front left, front right, front center, surround left, surround right, surround back left and surround back right speakers. Note: You can use surround back speaker terminals as M (Multiroom) SPEAKER B terminals, when you use no surround back speaker. 7