Motorola DS6707-DP20411ZZR Reference Guide - Page 27
ADF Programming: Normal Data Entry. Duration of tones are short., Scanning - specifications
View all Motorola DS6707-DP20411ZZR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Scanning 2 - 3 Table 2-1 Beeper Definitions (Continued) Beeper Sequence Indication Fast warble beep Aborting MPDF sequence. Low/high beeps Flushing an already empty MPDF buffer. ADF Programming: Normal Data Entry. Duration of tones are short. High/low beeps Enter another digit. Add leading zeros to the front if necessary. Low/low beeps Enter another alphabetic character or scan the End of Message bar code. High/high beeps Enter another criterion or action, or scan the Save Rule bar code. High/low/high/low beeps Rule saved. Rule entry mode exited. High/low/low beeps All criteria or actions cleared for current rule, continue entering rule. Low beep Delete last saved rule. The current rule is left intact. Low/high/high beeps All rules are deleted. ADF Programming: Error Indications. Duration of tones are very long. Low/high/low/high beeps Out of rule memory. Erase some existing rules, then try to save rule again. (It is not necessary to re-enter the current rule.) Low/high/low beeps Cancel rule entry. Rule entry mode exited because of an error or the user asked to exit rule entry. Low/high beeps Entry error, wrong bar code scanned. Re-enter criterion or action. All previously entered criteria and actions are retained. Criteria or action list is too long for a rule. Host Specific USB only 4 short high beeps The digital imager scanner has not completed initialization. Wait several seconds and scan again. Low/medium/high beeps Communication with the bus must be established before the digital imager scanner upon scanning a USB can operate at the highest power level. device type Low/medium/high beeps The USB bus can put the digital imager scanner in a state where power to the occur more than once. digital imager scanner is cycled on and off more than once. This is normal and usually happens when the PC cold boots. RS-232 only 1 short high beep A character is received and Beep on is enabled.