Motorola DS6707-DP20411ZZR Reference Guide - Page 95
Simple Serial Interface Default Parameters, SSI Interface
View all Motorola DS6707-DP20411ZZR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
SSI Interface 6 - 3 Simple Serial Interface Default Parameters Table 6-1 lists the defaults for the SSI host. There are two ways to change the default values: • Scan the appropriate bar codes in this guide. These new values replace the standard default values in memory. To recall the default parameter values, scan the Set Default Parameter on page 4-4. • Download data through the device's serial port using SSI. Hexadecimal parameter numbers appear in this chapter below the parameter title, and options appear in parenthesis beneath the accompanying bar codes. See the Simple Serial Interface (SSI) Programmer's Guide for detailed instructions for changing parameters using this method. NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and miscellaneous default parameters. Table 6-1 SSI Interface Parameter Defaults Parameter Parameter Number Default Baud Rate 9Ch 9600 Parity 9Eh None Check Parity 97h Enable Software Handshaking 9Fh ACK/NAK Host RTS Line State 9Ah Low Decode Data Packet Format EEh Send Raw Decode Data Stop Bits 9Dh 1 Host Serial Response Time-out 9Bh 2 sec Host Character Time-out EFh 200 msec Multipacket Option F0h 4Eh Option 1 Interpacket Delay F0h 4Fh 0 ms Event Reporting Decode Event F0h 00h Disable Boot Up Event F0h 02h Disable Parameter Event F0h 03h Disable Page Number 6-4 6-6 6-7 6-7 6-8 6-8 6-9 6-10 6-11 6-12 6-13 6-14 6-15 6-15 NOTE SSI interprets Prefix, Suffix1, and Suffix2 values listed in Table A-1 on page A-1 differently than other interfaces. SSI does not recognize key categories, only the 3-digit decimal value. The default value of 7013 is interpreted as CR only.