Home » Motorola Manuals » Barcode Scanners » Motorola DS6707-DP20411ZZR » Manual Viewer

Motorola DS6707-DP20411ZZR Reference Guide - Page 93

SSI Interface, Introduction

View all Motorola DS6707-DP20411ZZR manuals

Add to My Manuals
Save this manual to your list of manuals

Page 93 highlights

Chapter 6 SSI Interface Introduction This chapter describes how to set up the digital imager scanner with a Simple Serial Interface (SSI) host. When using SSI, program the digital imager scanner via bar code menu or SSI host commands. Throughout the programming bar code menus, default values are indicated with asterisks (*). * Indicates Default *Baud Rate 9600 (06h) Feature/Option Option Hex Value for programming via SSI command NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the screen, be sure to set the document magnification to a level where you can see the bar code clearly, and bars and/or spaces are not merging.

Section	Page
Symbol DS6707 Product Reference Guide	1
Patents	4
Revision History	5
Table of Contents	7
About This Guide	17
Introduction	17
Configurations	17
Chapter Descriptions	17
Notational Conventions	18
Related Documents	19
Service Information	19
Getting Started	20
Introduction	20
Supported Interfaces	21
Unpacking	21
Setting Up the Digital Imager Scanner	22
Installing the Interface Cable	22
Removing the Interface Cable	22
Connecting Power (if required)	23
Configuring the Digital Imager Scanner	23
Mounting the Digital Imager Scanner	23
Desk Mount	23
Wall Mount	24
Scanning	25
Introduction	25
Beeper Definitions	26
LED Definitions	28
Scanning in Hand-Held Mode	28
Scanning with the Digital Imager Scanner	28
Aiming	30
Scanning in Presentation Mode	31
Decode Zones	32
Symbol DS6707-SR Standard Range Digital Imager Scanner - 1D Bar Codes	32
Symbol DS6707-SR Standard Range Digital Imager Scanner - 2D Bar Codes	33
Symbol DS6707-DC Document Capture Digital Imager Scanner - 1D Bar Codes	34
Symbol DS6707-DC Document Capture Digital Imager Scanner - 2D Bar Codes	35
Symbol DS6707-DP Direct Part Mark Digital Imager Scanner - 1D and PDF417 Bar Codes	36
Symbol DS6707-DP Direct Part Mark Digital Imager Scanner - 2D Bar Codes	37
Symbol DS6707-HD High Density Digital Imager Scanner - 1D and PDF417 Bar Codes	38
Symbol DS6707-HD High Density Digital Imager Scanner - 2D Bar Codes	39
Maintenance & Technical Specifications	41
Introduction	41
Maintenance	41
Troubleshooting	42
Technical Specifications	44
Digital Imager Scanner Signal Descriptions	48
User Preferences & Miscellaneous Digital Imager Scanner Options	49
Introduction	49
Scanning Sequence Examples	50
Errors While Scanning	50
User Preferences and Miscellaneous Options - Parameter Defaults	50
User Preferences	52
Set Default Parameter	52
Parameter Scanning	53
Beeper Tone	53
Beeper Volume	54
Power Mode	54
Time Delay to Low Power Mode	55
Trigger Mode	56
Picklist Mode	57
Decode Session Timeout	58
Timeout Between Decodes, Same Symbol	58
Decoding Illumination	59
DP Illumination	60
Decode Aiming Pattern	61
Fuzzy 1D Processing	61
Decode Mirror Images (Data Matrix Only)	62
Miscellaneous Scanner Parameters	63
Transmit Code ID Character	63
Prefix/Suffix Values	64
Scan Data Transmission Format	65
FN1 Substitution Values	66
Transmit “No Read” Message	67
Imaging Preferences	69
Introduction	69
Scanning Sequence Examples	70
Errors While Scanning	70
Imaging Preferences Parameter Defaults	70
Imaging Preferences	72
Operational Modes	72
Low Light Enhancement	73
Presentation Mode Field of View	73
Image Capture Autoexposure	74
Image Capture Illumination	74
Illumination Bank Control	75
Fixed Exposure	76
Fixed Gain	76
Gain/Exposure Priority for Snapshot Mode	77
Snapshot Mode Timeout	78
Snapshot Aiming Pattern	78
Image Cropping	79
Crop to Pixel Addresses	80
Image Size (Number of Pixels)	81
Image Brightness (Target White)	82
JPEG Image Options	82
JPEG Target File Size	83
JPEG Quality and Size Value	83
Image Enhancement	84
Image File Format Selector	85
Bits Per Pixel	86
Signature Capture	87
Signature Capture File Format Selector	88
Signature Capture Bits Per Pixel	89
Signature Capture Width	90
Signature Capture Height	90
Signature Capture JPEG Quality	90
Video View Finder	91
Target Video Frame Size	91
Video View Finder Image Size	92
SSI Interface	93
Introduction	93
Connecting Using Simple Serial Interface	94
Simple Serial Interface Default Parameters	95
SSI Host Parameters	96
Baud Rate	96
Parity	98
Check Parity	99
Software Handshaking	99
Host RTS Line State	100
Decode Data Packet Format	100
Stop Bit Select	101
Host Serial Response Time-out	102
Host Character Time-out	103
Multipacket Option	104
Interpacket Delay	105
Event Reporting	106
Decode Event	106
Boot Up Event	107
Parameter Event	107
USB Interface	109
Introduction	109
Connecting a USB Interface	110
USB Parameter Defaults	111
USB Host Parameters	112
USB Device Type	112
Symbol Native API (SNAPI) Status Handshaking	113
USB Country Keyboard Types (Country Codes)	114
USB Keystroke Delay	116
USB CAPS Lock Override	116
USB Ignore Unknown Characters	117
Emulate Keypad	117
Emulate Keypad with Leading Zero	118
USB Keyboard FN 1 Substitution	118
Function Key Mapping	119
Simulated Caps Lock	119
Convert Case	120
ASCII Character Set for USB	121
RS-232 Interface	131
Introduction	131
Connecting an RS-232 Interface	132
RS-232 Parameter Defaults	133
RS-232 Host Parameters	134
RS-232 Host Types	136
Baud Rate	137
Parity	139
Stop Bit Select	140
Data Bits	140
Check Receive Errors	141
Hardware Handshaking	141
Software Handshaking	143
Host Serial Response Time-out	145
RTS Line State	146
Beep on <BEL>	146
Intercharacter Delay	147
Nixdorf Beep/LED Options	148
Ignore Unknown Characters	148
ASCII Character Set for RS-232	149
123Scan	155
Introduction	155
123Scan Parameter	155
Symbologies	157
Introduction	157
Scanning Sequence Examples	157
Errors While Scanning	158
Symbology Parameter Defaults	158
UPC/EAN	163
Enable/Disable UPC-A	163
Enable/Disable UPC-E	163
Enable/Disable UPC-E1	164
Enable/Disable EAN-8/JAN-8	164
Enable/Disable EAN-13/JAN-13	165
Enable/Disable Bookland EAN	165
Decode UPC/EAN/JAN Supplementals	166
User-Programmable Supplementals	169
UPC/EAN/JAN Supplemental Redundancy	170
Transmit UPC-A Check Digit	170
Transmit UPC-E Check Digit	171
Transmit UPC-E1 Check Digit	171
UPC-E1 Preamble	174
Convert UPC-E1 to UPC-A	175
UCC Coupon Extended Code	178
ISSN EAN	178
Code 128	179
Enable/Disable Code 128	179
Set Lengths for Code 128	179
Enable/Disable GS1-128 (formerly UCC/EAN-128)	181
Enable/Disable ISBT 128	181
ISBT Concatenation	182
Check ISBT Table	183
ISBT Concatenation Redundancy	183
Code 39	184
Enable/Disable Code 39	184
Enable/Disable Trioptic Code 39	184
Convert Code 39 to Code 32	185
Code 32 Prefix	185
Set Lengths for Code 39	186
Code 39 Check Digit Verification	187
Transmit Code 39 Check Digit	188
Code 39 Full ASCII Conversion	188
Code 39 Buffering (Scan & Store)	189
Code 93	192
Enable/Disable Code 93	192
Set Lengths for Code 93	192
Code 11	194
Code 11	194
Set Lengths for Code 11	194
Code 11 Check Digit Verification	196
Transmit Code 11 Check Digits	197
Interleaved 2 of 5 (ITF)	198
Enable/Disable Interleaved 2 of 5	198
Set Lengths for Interleaved 2 of 5	198
I 2 of 5 Check Digit Verification	200
Transmit I 2 of 5 Check Digit	200
Convert I 2 of 5 to EAN-13	201
Discrete 2 of 5 (DTF)	202
Enable/Disable Discrete 2 of 5	202
Set Lengths for Discrete 2 of 5	202
Codabar (NW - 7)	204
Enable/Disable Codabar	204
Set Lengths for Codabar	204
CLSI Editing	206
NOTIS Editing	206
MSI	207
Enable/Disable MSI	207
Set Lengths for MSI	207
MSI Check Digits	208
Transmit MSI Check Digit(s)	209
MSI Check Digit Algorithm	209
Chinese 2 of 5	210
Enable/Disable Chinese 2 of 5	210
Matrix 2 of 5	211
Enable/Disable Matrix 2 of 5	211
Set Lengths for Matrix 2 of 5	212
Matrix 2 of 5 Redundancy	213
Matrix 2 of 5 Check Digit	213
Transmit Matrix 2 of 5 Check Digit	214
Inverse 1D	215
Postal Codes	216
US Postnet	216
US Planet	216
Transmit US Postal Check Digit	217
UK Postal	217
Transmit UK Postal Check Digit	218
Japan Postal	218
Australian Postal	219
Netherlands KIX Code	219
USPS 4CB/One Code/Intelligent Mail	220
UPU FICS Postal	220
GS1 DataBar	221
GS1 DataBar-14	221
GS1 DataBar Limited	221
GS1 DataBar Expanded	222
Convert GS1 DataBar to UPC/EAN	222
Composite	223
Composite CC-C	223
Composite CC-A/B	223
Composite TLC-39	224
UPC Composite Mode	225
Composite Beep Mode	226
GS1-128 Emulation Mode for UCC/EAN Composite Codes	226
2D Symbologies	227
Enable/Disable PDF417	227
Enable/Disable MicroPDF417	227
Code 128 Emulation	228
Data Matrix	229
Data Matrix Inverse	230
Maxicode	231
QR Code	231
QR Inverse	232
MicroQR	233
Aztec	233
Aztec Inverse	234
Redundancy Level	235
Redundancy Level 1	235
Redundancy Level 2	235
Redundancy Level 3	235
Redundancy Level 4	236
Security Level	237
Intercharacter Gap Size	238
Report Version	238
Macro PDF Features	239
Flush Macro Buffer	239
Abort Macro PDF Entry	239
Advanced Data Formatting	241
Introduction	241
Rules: Criteria Linked to Actions	241
Using ADF Bar Codes	242
ADF Bar Code Menu Example	242
Rule 1: The Code 128 Scanning Rule	243
Rule 2: The UPC Scanning Rule	243
Alternate Rule Sets	243
Rules Hierarchy (in Bar Codes)	244
Default Rules	245
ADF Bar Codes	245
Special Commands	248
Pause Duration	248
Begin New Rule	248
Save Rule	248
Erase	249
Quit Entering Rules	249
Disable Rule Set	250
Criteria	251
Code Types	251
Code Lengths	258
Message Containing A Specific Data String	262
Actions	267
Send Data	267
Setup Field(s)	270
Modify Data	277
Pad Data with Spaces	278
Pad Data with Zeros	282
Beeps	287
Send Keystroke (Control Characters and Keyboard Characters)	287
Send Right Control Key	323
Send Graphic User Interface (GUI) Characters	324
Turn On/Off Rule Sets	329
Alphanumeric Keyboard	331
Standard Default Parameters	345
Programming Reference	355
Symbol Code Identifiers	355
AIM Code Identifiers	357
Sample Bar Codes	363
Code 39	363
UPC/EAN	363
UPC-A, 100%	363
EAN-13, 100%	364
Code 128	364
Interleaved 2 of 5	364
GS1 DataBar-14	365
PDF417	365
Data Matrix	365
Maxicode	366
QR Code	366
US Postnet	366
UK Postal	367
Numeric Bar Codes	369
Numeric Bar Codes	369
Cancel	370
ASCII Character Sets	371
Index	393

Match case Limit results 1 per page

Chapter 6 SSI Interface

Introduction

This chapter describes how to set up the digital imager scanner with a Simple Serial Interface (SSI) host. When

using SSI, program the digital imager scanner via bar code menu or SSI host commands.

Throughout the programming bar code menus, default values are indicated with asterisks (

Baud Rate 9600

(06h)

Feature/Option

Indicates Default

Option Hex Value for

programming via SSI

command

NOTE

Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the

screen, be sure to set the document magnification to a level where you can see the bar code clearly, and

bars and/or spaces are not merging.