Motorola H201 User Guide - Page 18
Setting the flash time, Setting the area code, Registration, To reset all settings, Paging/Find
View all Motorola H201 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
NOTE If pulse mode is selected, press TONE/* to switch from pulse to tone dialing temporarily when dialing out. After the call is ended, the dial mode will change back to pulse. 3.16 Setting the flash time The default flash time is 600MS. It is unlikely that you should need to change this setting unless advised to do so. 1. Press MENU and then VOL+ or REDIAL/VOL- to select SETUP BS. 2. Press MENU and then VOL+ or REDIAL/VOL- to select FLASH TIME. 3. Press MENU and then VOL+ or REDIAL/VOL- to the flash time you want. (8 options are available: 90, 100, 110, 250, 300, 400, 600 and 700MS) 4. Press MENU to save. 3.17 Setting the area code 1. Press MENU and then VOL+ or REDIAL/VOL- to select SETUP BS. 2. Press MENU and then VOL+ or REDIAL/VOL- to select AREA CODE. 3. Press MENU and enter the area code. 4. Press MENU to save. 3.18 Registration Up to 5 handsets can be registered to one base. The original handset is pre-registered to use. Additional handsets must be registered to the base before you can use them. To register an additional handset, 1. Press MENU and then VOL+ or REDIAL/VOL- to select SETUP HS. 2. Press MENU and then VOL+ or REDIAL/VOL- to select REGISTRATION. 3. Press MENU and then VOL+ or REDIAL/VOL- to select YES or NO. 4. Select YES and press MENU to enter the registration procedure as below: 1. Press and hold FIND for 4 seconds on base, and then release. 2. Place the unregistered cordless handset on the charger. 3. A confirmation tone is generated if registration is successful. HANDSET X is displayed where X denotes the number of handsets and the phone goes back to idle. To register an originally unregistered handset, follow steps 1 through 3 above. 3.19 To reset all settings 1. Press MENU and VOL+ or REDIAL/VOL- to select RESET SETTINGS. 2. Press MENU and VOL+ or REDIAL/VOL- to select ALL SETTINGS. 3. Press MENU to select YES. Then all the personalized settings will be reset to default. NOTE All of your phonebook entries, calls list and redial list will remain unchanged. 3.20 Paging/Find handset Press FIND on the base. All handsets registered to the base will ring. To stop the paging, press FIND again, or press any key on the handset, or place the handset on the base. 18 Using the phone