NEC LT154 User Manual - Page 18

Wiring Diagram Document Camera VCR, DVD Player or LaserDisc Player LT156 DVI To video, S-video, and audio inputs on the projector. VIDEO PC CONTROL S-VIDEO RGB AUDIO Macintosh or Compatibles (Desktop type or notebook type) RGB Signal cable (supplied) To mini D-Sub 15-pin connector on the projector. It is recommended that you use a commercially available distribution amplifier if connecting a signal cable longer than the supplied one. For LT156: DVI-D - DVI-D signal cable (supplied) To DVI connector on the projector. Optional Component V cable IBM VGA or Compatibles (Desktop type or notebook type) DVD Player (with component output) NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on the power to the notebook PC. In most cases signal cannot be output from RGB output unless the notebook PC is turned on after connecting with the projector. NOTE: * If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power management software. * If you accidentally hit the POWER button on the remote control, wait 60 seconds and then press the POWER button again to resume. NOTE: If using video, S-video, or audio cables, the cables should be 3 m (9.8 feet) or shorter. For LT156: NOTE: Some personal computers or video cards may not offer images correctly on LT156. To connect a DVI connector on your computer to LT156, attach the supplied DVI-D - DVI-D signal cable to the DVI connector on the projector. If you use a separately sold DVI cable, images may not be correctly displayed. NOTE: The DVI connector can accept a maximum resolution of 1024x768(XGA) when DVI (DIGITAL) input is selected. E - 18