NEC LT154 User Manual - Page 26

Adjust the Tilt Foot 1. Lift the front edge of the projector. 2. Press the Tilt button on the front of the projector to extend the ad- justable tilt foot (maximum height). Adjust the Image Using Auto Adjust The Auto Adjust function automatically optimizes the image in RGB mode. [Poor picture] POWESRTATAUCSPCCESCSARD STAONN/D BY ADJAUUTSTO SOURCE CANCEL ENTER SELECT 1 MENU RGB C CARD USB VIDEO PC CONTROL S-VIDEO AUDIO 2 AC IN 3. Press and hold the Tilt button. 4. Lower the front of the projector to the desired height and release the button to lock the Adjustable tilt foot. There is approximately 10 degrees of up and down adjustment for the front of the projector. [Normal picture] POWESRTATAUCPSCCESCSARD STAONN/D BY ADJAUUTSTO SOURCE CANCEL ENTER SELECT 4 MENU AUDIO RGB C CARD USB VIDEO PC CONTROL S-VIDEO 3 AC IN Do not use the tilt-foot for purposes other than originally intended. Misuses such as gripping the tilt-foot or hanging on the wall can cause damage to the projector. To fine-adjust the height of the rear foot, remove the spacer (black rubber) and rotate the rear foot to the desired height. * If the projected image does not appear square to the screen then use keystone correction for proper adjustment. C ER SOURCE AUATDOJUST PCACCCASRETSDASTPUOSWER ONS/TAND BY GB AUDIO Down Up Spacer OFF ON VIDEO S-VIDEO AUTO ADJ. RGB 1 RGB 2 PJ MENU LASER SELECT ENTER CANCEL SOURCE AUATDOJUST ONS/TAND BY Press the Auto Adjust button to adjust Position-H/V and Pixel Clock/ Phase for an optimal picture. Some signals may not be displayed correctly or take time to switch between sources. NOTE: For LT156 * The horizontal and vertical position adjustements are not stored in memory on LT156. * The Pixel Clock and Phase items are not available for DVI digital signal on LT156. max. min. 16mm E - 26