NaceCare TTV678 TTV678 Owners Manual (External Charger) - Page 15

Emergency-stop button and horn Fig.26 The TTV-678 is equipped with an electronic braking system. Simply lift your foot from the accelerator and the machine will stop. In an emergency, strike the emergency-stop isolator button The machine will be disabled. To reset, turn isolator button clockwise (see Fig.26). After resetting the emergency stop button, to restart the machine ,turn the ignition key to the off then the on position again. The horn is located on the right-hand side of the operator control panel (see Fig.26a). Fig.26a ! ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT AND RELEVANT SAFETY SIGNS ARE DISPLAYED. ! Machine in use To operate, select forward or reverse, press the accelerator pedal. Vacuum pick-up, water-flow and chemical-dose will turn on automatically and the machine will move forward. The clean water / chemical mix is dispersed evenly via 'THRU- FEED' scrubbing brushes. The waste water is then retrieved by the suction floor-tool (see Fig.27). Overlap each scrubbing path by 10cm to ensure an even clean. Do not operate the machine on inclines that exceed 11%. Fig.27 NOTE: Care must be taken to reduce speed when cornering or when manoeuvring around obstacles.. If streaking occurs wipe floor-tool blades clean (see Fig.28). On heavily soiled floors use a 'double scrub' technique. First pre-scrub the floor with the floor-tool in the raised position, allow the chemical time to work then scrub the area a second time with the floor-tool lowered. Fig.28 15