NaceCare TTV678 TTV678 Owners Manual (External Charger) - Page 17

Machine Cleaning ! ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF PRIOR TO ANY MAINTENANCE. ! After use, empty waste-water tank using emptying hose A and flush-out with clean water. Next remove floor-tool vacuum hose and flush out with clean water. B Next empty clean water tank, using emptying hose C and again flush out with clean water. A Before removing B separator, first pull-off connected hoses. Whilst pressing in the C separator toggles, remove hood and rinse using clean water. The hood also has a sealing-rubber which should be examined at every clean-down. Located in your waste water (top) tank is a full tank switch, this stops your machine from working once the waste water reaches its maximum limit. Sometimes the switch gets clogged and blocked, clean to ensure correct operation (see page 14). Remove white filter and rinse using clean water, and refit. IMPORTANT: Never use the machine without the recommended filter as it may cause damage to the machine. Remove debris basket filter and rinse using clean water, and refit. IMPORTANT: If the debris basket is allowed to become clogged, vacuum performance can deteriorate. The clean debris basket filter is located under the filler cap. Remove debris basket filter and rinse using clean water, and refit. The secondary clean-water tank filter is located to the rear of the battery compartment, and should be checked at regular intervals. Lift white plug and remove the filter, rinse and refit. Ensure tank has been emptied and care is taken when working in the vicinity of batteries. NOTE: ANY SPILLS SHOULD BE WIPED-UP BEFORE TANK IS LOWERED. 17