Netgear FE108 Installation Guide - Page 39
Patch Panels and Cables, as shown in C-3. - rating
UPC - 606449000894
View all Netgear FE108 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Installation Guide for the Model FE104 and Model FE108 Fast Ethernet Hubs Patch Panels and Cables If you are using patch panels, make sure that they meet the 100BASE-T requirements. NETGEAR recommends Category 5 UTP cable for all patch cables and work area cables to ensure that your UTP patch cable rating meets or exceeds the distribution cable rating. To wire patch panels, you need two Category 5 UTP cables with an RJ-45 connector at each end, as shown in Figure C-3. 1 2 1 87654321 87654321 Key: 1 = RJ-45 connector 2 = Category 5 UTP patch cable 5525.1 Figure C-3. Category 5 UTP patch cable with male RJ-45 connector at each end Note: Flat "silver satin" telephone cable may have the same RJ-45 connector. However, using telephone cable will result in excessive collisions and cause the attached port to be partitioned or disconnected from the network. Fast Ethernet and Cabling Guidelines C-5