Netgear FS728TLP Hardware Installation Guide - Page 11

ProSAFE Fast Ethernet PoE Smart Switch FS728TLP Table 1. LED descriptions (continued) Port LED Twenty-four 10/100BASE-T Link/ACT ports (one LED for each port) Note: The LED mode selector button needs to be in the Link/ACT mode. Four Gigabit Ethernet ports (one LED for each port: 25, 26, 27T, and 28T) Link/ACT Two SFP GBIC slots (one LED for each slot: 27F and 28F) Link/ACT Designation • Off. No link is established on the port. • Solid green. A valid 100 Mbps link is established on the port. • Blinking green. Packet transmission or reception occurs at 100 Mbps on the port. • Solid yellow. A valid 10 Mbps link is established on the port. • Blinking yellow. Packet transmission or reception occurs at 10 Mbps on the port. • Off. No link is established on the port. • Solid green. A valid 1000 Mbps link is established on the port. • Blinking green. Packet transmission or reception occurs at 1000 Mbps on the port. • Solid yellow. A valid 10 or 100 Mbps link is established on the port. • Blinking yellow. Packet transmission or reception occurs at 10 or 100 Mbps on the port. • Off. No link is established on the GBIC in the slot. • Solid green. A valid 1000 Mbps link is established on the GBIC in the slot. • Blinking green. Packet transmission or reception occurs at 1000 Mbps on the GBIC in the slot. • Solid yellow. A valid 100 Mbps link is established on the GBIC in the slot. • Blinking yellow. Packet transmission or reception occurs at 100 Mbps on the GBIC in the slot. Product Label The product label on the back panel of the switch shows the hardware model number and version, the software version, the unique MAC address, and the unique serial number. The following figure shows a generic product label. Figure 6. Generic product label Introduction and Hardware Description 11