Netgear FS750AT FS750 Reference Manual - Page 30

Checking the Installation Before you apply power: • Inspect the equipment thoroughly. • Verify that all cables are installed correctly. • Check cable routing to make sure cables are not damaged or create a safety hazard. • Be sure all equipment is mounted properly and securely. Applying AC Power The switches do not have an ON/OFF switch; the only method of applying or removing AC power is by connecting or disconnecting the power cord. Before you connect the power cord, select an AC outlet that is not controlled by a wall switch, which can turn off power to the switch. After you select an appropriate outlet, use the following procedure to apply AC power. 8. Connect the female end of the supplied AC power adapter cable to the power outlet on the back of the switch 9. Connect the 3-pronged end of the AC power adapter cable to a grounded 3-pronged AC outlet. When you apply power: • The green Power LED on the switch's front panel goes on. • The green Link LED on each connected RJ-45 port goes on. If the green Power LED does not go on, check that the power cable is plugged in correctly and that the power source is good. If this does not resolve the problem, refer to Chapter 5, Troubleshooting. When power is applied, the switch conducts a power-on self-test (POST) to verify operation. After the switch passes the POST, it is functional and ready to pass data. installation 4-6