Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 215

Software Rev: xxx xxx xxx Serial Num: xxx xxx xxx Mfg Name: xxx xxx xxx Model Name: xxx xxx xxx Asset ID: xxx xxx xxx Location Subtype: elin Info: xxx xxx xxx Extended POE Device Type: pseDevice Extended POE PSE Available: 0.3 Watts Source: primary Priority: critical Extended POE PD Required: 0.2 Watts Source: local Priority: low Managed Switch CLI Manual, Release 8.0 Denial of Service Commands This section describes the commands you use to configure Denial of Service (DoS) Control. The software provides support for classifying and blocking specific types of Denial of Service attacks. You can configure your system to monitor and block these types of attacks: • SIP=DIP: Source IP address = Destination IP address. • First Fragment:TCP Header size smaller then configured value. • TCP Fragment: IP Fragment Offset = 1. • TCP Flag: TCP Flag SYN set and Source Port < 1024 or TCP Control Flags = 0 and TCP Sequence Number = 0 or TCP Flags FIN, URG, and PSH set and TCP Sequence Number = 0 or TCP Flags SYN and FIN set. • L4 Port: Source TCP/UDP Port = Destination TCP/UDP Port. • ICMP: Limiting the size of ICMP Ping packets. Switching Commands v1.0, July 2009 3-179