Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 407

Managed Switch CLI Manual, Release 8.0 Configuring the Switch Management CPU To manage the switch via the web GUI or telnet, an IP address needs to be assigned to the switch management CPU. Whereas there are CLI commands that can be used to do this, ezconfig simplifies the task. The tool is applicable to all NETGEAR 7000-series managed switches, and allows you to configure the following parameters: 1. The administrator's user password and administrator-enable password 2. Management CPU IP address and network mask 3. System name and location information The tool is interactive and uses questions to guide you through the steps required to perform its task. At the end of the session, it will ask you if you want to save the changed information. To see exactly what has been changed by ezconfig at the end of the session, use the show running-config command. To perform any switch configuration other than the items listed above, use other CLI commands or the Web GUI. ezconfig This command sets the IP address, subnet mask and gateway of the device. The IP address and the gateway must be on the same subnet. Format Mode ezconfig Privileged EXEC Management Commands 7-2 v1.0, July 2009