Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 301

Managed Switch CLI Manual, Release 8.0 {deny | permit} (MAC ACL) This command creates a new rule for the current MAC access list. Each rule is appended to the list of configured rules for the list. Note: The 'no' form of this command is not supported, since the rules within a MAC ACL cannot be deleted individually. Rather, the entire MAC ACL must be deleted and re-specified. Note: An implicit 'deny all' MAC rule always terminates the access list. A rule may either deny or permit traffic according to the specified classification fields. At a minimum, the source and destination MAC value must be specified, each of which may be substituted using the keyword any to indicate a match on any value in that field. The remaining command parameters are all optional, but the most frequently used parameters appear in the same relative order as shown in the command format. The Ethertype may be specified as either a keyword or a four-digit hexadecimal value from 0x0600-0xFFFF. The currently supported values are: appletalk, arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp. Each of these translates into its equivalent Ethertype value(s). Ethertype Keyword appletalk arp ibmsna ipv4 ipv6 ipx mplsmcast mplsucast netbios novell pppoe rarp Corresponding Value 0x809B 0x0806 0x80D5 0x0800 0x86DD 0x8037 0x8848 0x8847 0x8191 0x8137, 0x8138 0x8863, 0x8864 0x8035 Quality of Service (QoS) Commands v1.0, July 2009 5-34