Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 498

Managed Switch CLI Manual, Release 8.0 Table 8-39: OSPFv3 Log Messages Component OSPFv3 OSPFv3 OSPFv3 Message Warning: OSPF LSDB is 90% full (15292 LSAs). The number of LSAs, 16992, in the OSPF LSDB has exceeded the LSDB memory allocation. LSA Checksum error detected for LSID 1.2.3.4 checksum 0x34f5. OSPFv3 Database may be corrupted. Cause OSPFv3 limits the number of Link State Advertisements (LSAs) that can be stored in the link state database (LSDB). When the database becomes 90 or 95 percent full, OSPFv3 logs this warning. The warning includes the current size of the database. When the OSPFv3 LSDB becomes full, OSPFv3 logs this message. OSPFv3 reoriginates its router LSAs with the R-bit clear indicating that OSPFv3 is overloaded. OSPFv3 periodically verifies the checksum of each LSA in memory. OSPFv3 logs this Table 8-40: Routing Table Manager Log Messages Component Routing Table Manager Routing Table Manager Message Cause RTO is full. Routing table contains 8000 best The routing table manager, also called routes, 8000 total routes. "RTO," stores a limited number of best routes, based on hardware capacity. When the routing table becomes full, RTO logs this alert. The count of total routes includes alternate routes, which are not installed in hardware. RTO no longer full. Bad adds: 10. Routing table contains 7999 best routes, 7999 total routes. When the number of best routes drops below full capacity, RTO logs this notice. The number of bad adds may give an indication of the number of route adds that failed while RTO was full, but a full routing table is only one reason why this count is incremented. Log Messages v1.0, July 2009 8-19