Netgear FSM7326P FSM7326P User Manual - Page 90
show network, Agetime, Format, IP Address, Subnet Mask, Default Gateway, Burned In MAC Address
UPC - 606449031072
View all Netgear FSM7326P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software Agetime Displays the address aging timeout for the associated forwarding database in IVL. In an SVL system, this will display the system's address aging timeout value in seconds. show network This command displays configuration settings associated with the switch's network interface. The network interface is the logical interface used for in-band connectivity with the switch via any of the switch's front panel ports. The configuration parameters associated with the switch's network interface do not affect the configuration of the front panel ports through which traffic is switched or routed. Format show network Mode Privileged EXEC and User EXEC IP Address Subnet Mask The IP address of the interface. The factory default value is 0.0.0.0 The IP subnet mask for this interface. The factory default value is 0.0.0.0 Default Gateway The default gateway for this IP interface. The factory default value is 0.0.0.0 Burned In MAC Address The burned in MAC address used for in-band connectivity. Locally Administered MAC Address If desired, a locally administered MAC address can be configured for in-band connectivity. To take effect, 'MAC Address Type' must be set to 'Locally Administered'. Enter the address as twelve hexadecimal digits (6 bytes) with a colon between each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0, i.e. byte 0 should have the following mask 'xxxx xx10'. The MAC address used by this bridge when it must be referred to in a unique fashion. It is recommended that this be the numerically smallest MAC address of all ports that belong to this bridge. However it is only required to be unique. When concatenated with dot1dStpPriority a unique BridgeIdentifier is formed which is used in the Spanning Tree Protocol. MAC Address Type Specifies which MAC address should be used for in-band connectivity. The choices are the burned in or the Locally Administered address. The factory default is to use the burned in MAC address. 8-24 202-10009-01_060204 Switching Commands