Netgear GS724Tv4 Hardware Installation Guide - Page 25

Step 4: Connect Devices to the Switch

Get Netgear GS724Tv4 PDF manuals and user guides View all Netgear GS724Tv4 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

GS716T, GS724T and GS748T Gigabit Smart Switch Step 4: Connect Devices to the Switch The following procedure describes how to connect computers to the switch's RJ-45 ports. The NETGEAR GS716T,GS724T,GS748T Series Smart Switch contains Auto Uplink™ technology, which allows the attaching of devices using either straight-through or crossover cables. Reset PWR ProSafe 24 Port 10/100/1000 Mbps Smart Switch Link/ACT SPD Green(1000M) Yellow(100M) FDX Link/ACT SPD FDX Figure 10. Connecting Devices to the Switch Connect each computer to an RJ-45 network port on the Switch front panel (Figure 10). Use Category 5 (Cat5) Unshielded Twisted-Pair (UTP) cable terminated with an RJ-45 connector to make these connections. Note: Ethernet specifications limit the cable length between the switch and the attached device to 100 m (328 ft.). 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
21
GS716T, GS724T and GS748T Gigabit Smart Switch
Step 4: Connect Devices to the Switch
The following procedure describes how to connect computers to the switch’s RJ-45 ports.
The NETGEAR GS716T,GS724T,GS748T Series Smart Switch contains Auto Uplink™
technology, which allows the attaching of devices using either straight-through or crossover
cables.
Link/ACT
SPD
Green(1000M)
Yellow(100M)
FDX
SPD
Link/ACT
FDX
ProSafe 24 Port 10/100/1000 Mbps Smart Switch
PWR
Figure 10. Connecting Devices to the Switch
Connect each computer to an RJ-45 network port on the Switch front panel (
Figure 10
). Use
Category 5 (Cat5) Unshielded Twisted-Pair (UTP) cable terminated with an RJ-45 connector
to make these connections.
Note:
Ethernet specifications limit the cable length between the switch and
the attached device to 100 m (328 ft.).