Netgear GS752TPSB GS7xxTS-TPS Software Admin Manual - Page 143
Fast Leave Admin Mode, Host Timeout, Maximum Response Time, MRouter Timeout, Query Mode
View all Netgear GS752TPSB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches To configure IGMP snooping settings for VLANs: 1. To enable IGMP snooping on a VLAN, enter the VLAN ID in the appropriate field and configure the IGMP Snooping values: • Fast Leave Admin Mode. Enable or disable the IGMP Snooping Fast Leave Mode for the specified VLAN ID. Enabling fast-leave allows the switch to immediately remove the layer 2 LAN interface from its forwarding table entry upon receiving an IGMP leave message for that multicast group without first sending out MAC-based general queries to the interface.You should enable fast-leave admin mode only on VLANs where only one host is connected to each layer 2 LAN port. This prevents the inadvertent dropping of the other hosts that were connected to the same layer 2 LAN port but were still interested in receiving multicast traffic directed to that group. Also, fast-leave processing is supported only with IGMP version 2 hosts. • Host Timeout. Sets the value for group membership interval of IGMP snooping for the specified VLAN ID. The valid range is (Maximum Response Time + 1) to 3600 seconds. • Maximum Response Time. Enter the amount of time in seconds that a switch will wait after sending a query on the VLAN because it did not receive a report for a particular group in that interface. The valid range is 1 to 25 seconds. The Maximum Response Time value must be less than the Host Timeout value. • MRouter Timeout. Enter the amount of time that a switch will wait to receive a query on the VLAN before removing it from the list of VLANs with multicast routers attached. Enter a value between 0 and 3600 seconds. The default is 0 seconds, which means there is no expiration. • Query Mode. Enable or disable the IGMP Querier Mode for the specified VLAN ID. • Query Interval. Enter the value for IGMP Query Interval for the specified VLAN ID. The valid range is 1-1800 seconds. The default is 60 seconds. 2. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. 143