Netgear GSM7228PS ProSafe Managed Switch Web Management User Manual - Page 559
Cable Test, Monitoring, Ports, Interface, Apply
UPC - 606449071696
View all Netgear GSM7228PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 559 highlights
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual Cable Test To display the Cable Test page, click Monitoring Ports> Cable Test. 1. Interface - Indicates the interface to which the cable to be tested is connected. 2. Click Apply to perform a cable test on the selected interface. The cable test may take up to 2 seconds to complete. If the port has an active link then the link is not taken down and the cable status is always "Normal". The command returns a cable length estimate if this feature is supported by the PHY for the current link speed. Note that if the link is down and a cable is attached to a 10/100 Ethernet adapter then the cable status may be "Open" or "Short" because some Ethernet adapters leave unused wire pairs unterminated or grounded. Chapter 7. Monitoring the System | 559