Netgear M5300-52G Command Line Interface (CLI) User Manual - Page 320

ProSafe Managed Switch show ip ospf stub table This command displays the OSPF stub table. The information below will only be displayed if OSPF is initialized on the switch. Format Modes show ip ospf stub table • Privileged EXEC • User EXEC Term Definition Area ID A 32-bit identifier for the created stub area. Type of Service The type of service associated with the stub metric. Switch CLI only supports Normal TOS. Metric Val The metric value is applied based on the TOS. It defaults to the least metric of the type of service among the interfaces to other areas. The OSPF cost for a route is a function of the metric value. Import Summary LSA Controls the import of summary LSAs into stub areas. show ip ospf traffic This command displays OSPFv2 packet and LSA statistics and OSPFv2 message queue statistics. Packet statistics count the packets and LSAs since OSPFv2 counters were last cleared (using the command clear ip ospf counters). Note: The clear ip ospf counters command does not clear the message queue high water marks. Format Mode show ip ospf traffic Privileged EXEC Parameter OSPFv2 Packet Statistics LSAs Retransmitted LS Update Max Receive Rate LS Update Max Send Rate Description The number of packets of each type sent and received since OSPF counters were last cleared. The number of LSAs retransmitted by this router since OSPF counters were last cleared. The maximum rate of LS Update packets received during any 5-second interval since OSPF counters were last cleared. The rate is in packets per second. The maximum rate of LS Update packets transmitted during any 5-second interval since OSPF counters were last cleared. The rate is in packets per second. Routing Commands 320